Search results

If it is the radiator that is leaking, instead of fitting another td rad I thought I'd be better off fitting a tdi one, 1 for the intercooler just for a little bit of power gain but mainly when I eventually fit a 200tdi a rad and intercooler is one thing I won't need to get.

Aw do all, my temp on my td (after a short period of heavy acceleration) increases up the temp gauge around the 1 oclock area whereas previously wouldn't move past the 11oclock position. I seem to be topping the water up quite often. There's no water in the oil nor is there any White smoke or...

The way I wind my cable on my winch evenly is to pull the cable out in a straight line with a good pair of gloves and keeping hands away from the fairleads/rollers. Hold the cable with one hand and operate the controller with the other hand, keep the cable as tight as possible as you wind in and...

:D:D:D:D I've finally found my clunk!!!!!!:D:D:D:D after replacing two front calipers, (couldn't be arsed messing about with pistons) renewed both bottom swivel bearings, one top swivel pin and bush, prop ujs checked along with bushes*, balljoints renewed, front diff out and checked then swapped...

To get the cable on your winch the first time correctly you must do so on load e.g. Winch another vehicle towards yours whilst laying the cable evenly across the drum, that then cures the cable. Wire cable is a pain in the arse at the best of times, but after you do the above it will be more...

There's a grub screw on the box to adjust backlash, screw that in to release the cover. (should, might I add:D)

Keep the money saving ideas coming:D I diddnt think of that actually if it lasts it's a bloody good idea, thanks redhand.

I bet I can, ial just hammerite em!....I think that's best then, replace the bush and save a few quid then get new ones. I've just replaced the seal so at the moment it's not leaking but I expect it to start ****ing out soon enough though. Thanks for your advice, I diddnt have much of an idea...

Tbh I would like to get a pair when I've got a few quid spare but I wanted a temporary fix. (easy fast and cheap)

Cheers guys, you've saved me £130! That's what I was quoted today, I diddnt ask for em to do it but that's what they said the damage would be. I had recently replaced the lower bearing but i diddnt notice any play in the top bush for some reason and I assumed that it would be an arse to get the...

Hi all, I've found the reason to my worsening clunk, the front top swivel pin/bush. It's well knackerd so it's beyond removing shims. The question is, can I remove the hub ass complete and do it in situ (removing the bush) or is it a case of a press, my lr manual doesn't explain in great detail...

Can you hear him fanatic?:D

No I just open the window :D

If none of the above sorts the problem, check the wire that clips to your fuel solonide, I have the same engine as you and a while back the wire came loose inside the connector on the solonide and as I drove it was fine for a bit then it cut out (no smoke or funny noises) it would start just...

Wet right leg, deafness, viberation whitefinger, steering wheel grove in his stomach because the seat won't go back, sore throat from shouting over the engine noise, soiled pants because there is **** loads of play in the steering so he's playing pinball between the central reservation and hard...

Ear muffs

The track rod is the bar that runs behind the front axel attached by two balljoints on the rear of each hub this does not have bushes. The tie rod/panhard rod, the bar that goes from the drivers side just below the steering box accross (slightly in front of the front axel) to a bracket located...

This is the only info regarding tracking I have but should be correct. 58.50 in-(1485.90 mm) hope this helps ya.

Just googled it and fortunatly they have a web site, £345 if i remember correctly. Thanks again mate. Hope your sale goes well, (make sure you are completely happy beforehand though, once it's gone it's gone)

Thanks for the info, ial give him a call in the week, can u give me a clue as to the price? (just so I know) thanks again mate.