Search results

I've never seen a Weber fitted landrover series cold start as well as a zenith styled one. Better power with Weber though. They always run out of torque over 45 mph when a hill is hit. Just my opinion

Yes it is looking like the best option.

Do you know the hijacker part number?

Ok, thanks for info.

To fit on a Salisbury?

It's a 109, back of chassis has been shortened. I often get told that.

Yes only replace shocks

This is my winch plate, completely separate to bullbar apart from the fairlead. 8 mm plate bolted down to some receives welded to Chassie. Welded where double skinned for the front spring mounts. If you don't want to weld you could also bolt some angle on the inside of chassis by bolting through...

The rover v8 should have timing marks on the timing cover. As long as the firing order is correct, I would recommend just adjusting the timing by feel, with a bit of experience it's better than a timing light in my opinion. Cheers

Hi all, I've been looking for some pump up adjustable rear air shocks for a series 3 109. I've failed to find and online. Does anyone know if they are available for if any thing can fit. Will be bracing and redesigning top mount so can be changed to suit different mount. Reason for air shocks...

No no signs of modified chassis

Yes those are the ones, I'll have to add one on. Just thought it was strange.

Hey, just gone to install a factory fuel tank in my ex Australian series 3 109. And it seams to be missing the outriggers, and no evidence they were ever there. Any one got any ideas to why . Cheers Riley

Hi, I'm using a conversation kit from motor and Diesel Engineering, it comes with the bush you mentioned. What part of the crankshaft do I have to cut? Is there a picture to clarify.

Hey, I'm fitting a Rover 3.9v8 with carbs into my series 3. I will be keeping the lt76 gearbox. Will a 3.9/discovery 1 clutch fit. Is the gear box input spine the same as the 3.9 clutch? And is the clutch it's self to big for the bell housing? Cheers Riley

It's a 109, will probably end up using 3.5 engine bell housing and clutch. Then manufacturer a adaptor plate for the series gearbox, I have a high ratio transfer case that I will be using as well

Thanks, do you know of any kits for sale.

Hi, planning of fitting a 3.5l rover engine into my 76 series 3, is there a conversation kit on the market? And what troubles have been found with this swap. Cheers Riley

Have checked all fuses and relays again. On back of radio only the 2 purple wires have power. Which other ones should ? Is there any fuses on the back of the amp that might affect this? And does the power come from the bcem?

Thanks these will definitely help😀