Your recommendation about steering rods
- Thread starter Menash
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
steve24v
Well-Known Member
- Posts
- 537
- Location
- Romsey Hampshire
I have the Terrafirma HD kit on mine, haven't driven it yet (still rebuilding).
Was easy to change just set the ball joints to the same position as the old ones.
Not sure if they are any better or worse than other HD kits. I went with these over standard as all the joints can be replaced rather than buying new arms
Was easy to change just set the ball joints to the same position as the old ones.
Not sure if they are any better or worse than other HD kits. I went with these over standard as all the joints can be replaced rather than buying new arms
- Posts
- 41,194
- Location
- East Dorset
OEM droplink rods have the ball joint that attaches to the drop arm crimped into place so that it cannot be removed, as I found out last month! I bought aftermarket, prolly, not in the UK so can't look at the box! cost me about £100.
Doing the front one won't affect the tracking as the rear one keeps it tracked, But DON'T lock the steering wheel when you put your new one on as if the wheels have moved it could be set too far out to be adjustable without taking it all off again, as I found out!!
(compared the lengths and set the new one to exactly the same as the old one, which should have been ok, then locked the steering wheel. It wouldn't fit so I assumed I'd made a boo-boo, and wound the outer BJ out another coupla turns. Put it back together, took it for a spin and the steering wheel was 45 degs out!) so much for the Haynes method!
The wheels must have moved unbeknownst to me, so back under, wind it back in again, slight readjustment on the outer end and back in it went perfectly straight.
But if I was doing the rear one, I'd be very careful about getting the length exactly right. And/or budget for a tracking session.
Doing the front one won't affect the tracking as the rear one keeps it tracked, But DON'T lock the steering wheel when you put your new one on as if the wheels have moved it could be set too far out to be adjustable without taking it all off again, as I found out!!
(compared the lengths and set the new one to exactly the same as the old one, which should have been ok, then locked the steering wheel. It wouldn't fit so I assumed I'd made a boo-boo, and wound the outer BJ out another coupla turns. Put it back together, took it for a spin and the steering wheel was 45 degs out!) so much for the Haynes method!
The wheels must have moved unbeknownst to me, so back under, wind it back in again, slight readjustment on the outer end and back in it went perfectly straight.
But if I was doing the rear one, I'd be very careful about getting the length exactly right. And/or budget for a tracking session.
Landmark2
Well-Known Member
- Posts
- 763
- Location
- Shropshire
Lemforder are OEM if you don't want LR. That's what I go for.
Griff
Griff
JUKE179r
Well-Known Member
- Posts
- 3,165
- Location
- Suffolkshire
I've got the HD TerraFirma. Both ball joints corroded after 6 months and the rod itself started to discolour.
