Recent content by uk03065

Hi don't know if this helps but mine stopped working on intermittent, I replaced the stalk and all was well. They have now stopped again, but if I wiggle the speed change toggle side to side numerous times I can get them to work now and again. I suspect another stalk is needed on mine.

Hi, My DHSE also have two switches/sensors of the near side of the oil cooler for information, so I think its standard

Fixed swapped out the centre switch pack and all working as they should no delay.

Hi Data Thanks for the Info Well I took off all the trim and looked at the connectors, removed and all look ok not corrosion all shiny pins etc, and looking at what each pin does the windows run from various connections and all other functions and switches work, no other errors If I...

Thanks for the replys For info they are not iced up just tried again in the rain, left running on drive for 20 mins and hey presto they start working rear switches don't work either, very strange they just start after a while. Carpet is slightly damp but not wet as such Will...

Hi My 2002 P38 windows only work after the car has been running for 10 minutes or so. I cant see it being a dodgy connection as its very consistent, get to the motorway in the morning run to work and they start working everytime. been like that for 2 weeks now Any ideas? why this...

well I finally cured the noise, don't know why but I re bleed the system put mu old modulator back on all to no avail. replaced the front pads (which were not worn out) and voila no noise.

Hi Yeah ive read that but during the bleeding procedure I can hear the pump running and it is not making a ticking noise, its only when I am driving it does it, if I press the brakes to make the pump come on it doesn't make the noise I can hear, its definitely speed related as the tick/clunk...

Hi Wammers I have bled the system numerous times and brakes are good and firm pedal pressure, its just the annoying noise. do you think I still have air in the modulator? Thanks

Well swapped out the modulator at weekend re bleed and it does exactly the same, quite an annoying ticking noise when lightly pressing the brake pedal, could it be the pressure switch on the pump? any help appreciated

well have bled the system 3 times (to the manual) still get the clicking noise when lightly pressing brake pedal, if I press hard it disappears. Anyway got a second hand modulator, anything I need to be aware of when swapping them over? Thanks

thanks, done some research on the older type which can fail, as mine is the later type can these fail or can I just put up with the noise

Can someone throw any light on this issue Range Rover P38 DHSE 2002 Abs Modulator SXC 1000000 My modulator starts making a clunking noise when I am braking very lightly, if I press the brakes harder the noise stops. I have cleaned out the reservoir which wasn't really dirty and renewed the...

Thanks data got your mod, what temperature would you set the coolant at (90 to 95?) thanks

PM sent Thanks