Recent content by TD5mm

Thanks. I am going to get it on the computer, but it just makes sense to me that if I have 12v to the compressor then the compressor should be running which it isn't. I have 12v to the right hand solenoid which to me is telling the solenoid to open to allow air to the right bag. This bag is...

Thanks will get it diagnosed

Hi all. Got an issue with my suspension. It's not dropping and its not raising. Compressor not coming on. There are 3 plugs within the compressor housing. Blue plug which I get about 3v accross. Another which I'm getting 14v. both these plugs go to the solenoids then there's a black plug...

Well today I fitted a new wastegate modulator valve and also fitted the new maf. So far all seems ok. Have give it a good run and no problems so fingers crossed.

Yep you guys were right 2 manifold bolts snapped. Top and bottom back end of manifold. Can even move the gasket. Now to get the buggers out! Thanks for all your input

Bit of an update. Drove home from Devon to the midlands today and car ran fine 3/4 of the way then whilst cruising at 70 it stated doing it again. Like kangarooing then loss of power again. Limped rest of way home. Been having a mess this afternoon. Found wastegate rod quite stiff. Can move it...

Checked throttle position sensor. All seems ok. Nice and secure. It's strange that only does it if I accelerate hard but if I build it up gradually its fine. Thanks for your replys

Had a look yesterday at the wiring harness and found a tiny amount of oil at the ecu. Nothing like I found last time. Cleaned all out but still same. Noticed though that if I build up speed steadily to around 2800 revs then floor it its fine. Just seems to do it if I floor it straight away like...

Yeah have cleaned ecu out before as had oil in it before. Changed loom etc. Going to have a look now to see if there is oil in it again. Where's the throttle position sensor plug though? Thanks

They have a maf sensor which I have a new one at home as I don't think mines working but never got around to fitting it. Disconnected maf though as apparently it puts engine back to default settings and no difference.

Where about is that plug? I'm away from home so don't have my rave with me. Thanks

Thanks will check. It has happened before but then cleared and been fine. So is an intermittent fault.

Hi all. Currently on holiday in sunny Devon and have developed a problem with my td5. Put my foot down and suddenly its like it revs then drops then revs then drops. This kept happening then it suddenly cleared but now seems to not let me go above 3000 revs. Like its holding back. Is this the...

Thanks everyone. Will go get one. Thanks for your time!

Yeah that small block that the pipes go to. Is that the waste gate modulator then? Thanks for your help and the pictures. Can I get one of those from any landrover specialist? Thanks again