Recent content by Taylorcraft

I think I owe you a drink :) the number of times I have taken that connection apart over the last couple of Months to change the engine oil cooler and the pipes then to put the pipes on the right way round and to change the split rad and I go and forget to plug it in :o. All sorted now. Thanks...

Had a mobile mechanic help me do the bolt up, oil light fine now and have been out towing the caravan and everything seems ok other than the info screen is now showing gearbox overheat. Have put Nanocom on but there are no faults any ware :confused: I did remove the battery while we were...

Where can I get one of these special tools. Think the part number is LRT-12-105. Looked on a few web sites but no luck.

:o Wedged a long bar on the sub frame and turned the engine over!

Well took everything apart to find the crankshaft pulley bolt undone ! Have got the bolt to 100Nm and marked it but can't move it much further. I put 2 bolts back in that hold the pulley on and wedged a crow bar in there. what do you do to hold the engine still?

Ok see what you mean now :) I done it up to 100nm and a bit, and the bit was about half a flat.

Have to say I'm confused :confused: what does the bolt have to do with the oil pump?:o

Hi, it's a diesel 2.5 1998

Changed the front crankshaft seal and oil cooler + pipes the other day which all went ok. On the way to work (10miles) I noticed the oil light starting to flicker on and off pulled over turned the engine off and back on again and all was fine then it started again. The car was running fine...

The numbers were from my Nano com as every now and then I have a flat spot when pulling away as you say they don't mean anything without the headings. If I could delete that post I would! Have checked the levels as you described and all is fine.

Hi, changed the fluid and the filter a couple of weeks ago, it was brown/black but had no burning smell.

Took the car to work this morning and still have the problem, when foot full (kick down) on the floor it hits the rev limiter around 4000rpm and will not change up unless I take my foot off the throttle slightly then it will. If I don't floor it the auto box works as it should. Is this just a...

Well :rolleyes: there was nothing on the dip stick so I have filled it up and will see if it makes a difference.

Foot on the floor and mine stays in first and hits rev limit at 4000 :confused:

Well here you go - Nano com info. looks like I can't post attachments!:( 82.83;61.75;103.46;103.46;2.33;0.6;11.96;750.75;CRUISE OFF 82.83;61.75;103.46;103.46;2.33;0.6;12.09;750.75;CRUISE OFF 82.83;59.04;103.46;103.46;2.33;0.6;12.61;750.75;CRUISE OFF...