Recent content by Stonesinboots

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. S

    Credit where its due...

    Must say I've had good service from them
  2. S

    manouvering/safety mirror needed Disco 300 ti

    Commercial motor factors, HGV mirrors There is a company Ashley mirrors, or glass, they do a full range of mirrors and arms. The type you are after are wide angle mirrors
  3. S

    Breaking - 300tdi Disco

    Have you still got the side exit exhaust, could it be posted? Cheers
  4. S

    Painting components underneath

    +1 Fantastic stuff
  5. S

    Rear load restraint bar

    I reuse transit tie down points with a 50mm square washer under it.
  6. S

    Rear seat bolts

    I had to do a bit of welding in that area, and replaced the bolts with m6 they dont need to be that long used m6 nyloc and penny washers on the other side.
  7. S

    Tachographs

    As above really, it has to be installed by an authorised person. Just had a couple of transits done just over £1000 each. Private use is the way to go, keep away hire and reward, CPC both driver and operator, bank account details (enough money to repair and operate the vehicle) and a ream of...
  8. S

    Tools for the job !

    Had a problem with Halfords as I didn't have the receipt. I told them that it was ok as I brought them on a debit card and they would have a record of it as it was only 2 years ago. They said they didn't keep records going back that far, funny that I don't keep receipts going back that far, Got...
  9. S

    Land rover discovery 6v ride on

    What tyres can I put on it?
  10. S

    Winch wire routingLookH

    Thanks for the offer, but I managed to get a bumper, winch, steering guard and yellow top battery for a bulk purchase price.
  11. S

    Winch wire routingLookH

    Cheers Paul thats a nice tidy install mate. (dont know where the LookH in the title came from??)
  12. S

    Winch wire routingLookH

    Hi, looking for some advice on where to run the 4 power cables for the winch. I am thinking holes,with grommets in the front panel under the horn. I have a remote solenoid that i'am mounting on the inner wing in front of the servo. Where do people fit the multiplug for the handset? I have a...
  13. S

    Halfords 3 tonne Axle Stands

    Must say I do rate the pro range for price and no quibble replacement. Only down side is the depth of there standard sockets which is too shallow compared to snap off. Good spot on those stands.
  14. S

    Defender Build Thread "A Long Road Ahead"

    Just read through the thread, top work sure you will keep it up.
  15. S

    What am i looking for

    Good luck with your disco, hope the trip worthwhile.
Back
Top