Recent content by Skuz86

Cheers,Tom at least I know where to get one now if the removal of the original proves to be a pain.

I was actually thinking of doing the same if I'm being honest Tom.😂

Hey Guys,thanks for all the information pictures and sound advice.I have just nipped out and plus gassed the 2 unions on the flexi so I will attempt to install at the weekend if the 🌧 and ❄️ cease long enough and I'll hopefully post a couple of pics as a reference for someone to compare my 2...

Thanks people,I have recently replaced the master slave and pedal spring but couldn't get the system to pressure up fully after bleeding. Turns out it was weeping fluid from the original flexi hose itself. When I received the kit it didn't contain any washers,but I notice the original flexi to...

Has anyone fitted one of these to a Defender Td5? And if so,how easy/hard is it? Is there any thing in particular to bear in mind whilst fitting?

Sorted! Ok I know the majority of you would sus this out for yourselves,but just incase there are any other people out there who are relatively new to the subtle nuances of Land rover maintenance,here is how I removed my clutch pedal pin by placing in a vise and using a 4.5mm pin punch placed in...

Oh ffs!! Sorry,It's the part circled on the diagram. It's the pin that keeps the clutch pedal in place.

Just had a look in the workshop manual and the part pictured in my previous post is the clutch pedal trunnion,not pivot pin. I have removed the rolled split pin,so I take it that you can dismantle it? Just wanted to ask if any of you lot had any experience taking this particular piece...

Hello All, does anyone know the correct way of removing the clutch pedal pivot pin so I can remove the actual pedal from the master clutch tower/body scrinson thingy? So I can grit blast it ready for repainting.I have removed the rolled split pin that holds it in. Does it just tap out? Or is...

Sorry about that,and thanks for the reply. I have a spare complete centrifugal filter housing,I was wondering how difficult it was to remove the existing one,I have the workshop manual and can see what I will have to remove when I get there it's just the getting there,I have the confidence to...

Hi all, has anybody here replaced their centrifugal oil filter housing? I was servicing my Td5 undid the bolts on the the housing and one sheared just below the head,so the rest is stuck in the alloy housing. I have a complete spare housing so I was going to swap them out and then attempt to...

Jimwyllie,thanks for the reply.i didn't realize you could screw it in too far,but I have screwed it in right up to the nut,that was how the old one was fitted.will do as you suggest tomorrow and get back to you.didnt know it would stop me selecting gears though??

Hi everyone, I have just replaced the reversing switch on my 02 double cab,put it all back together jumped in started it up.wont go into any gear and the brake warning light on dash won't go out now.Handbrake working fine,as was gearbox and gear selection before starting job no grinding gears or...

I knew there was an a in there somewhere.i did the vent flap seals the other nite but will look at the grommets tonight when I Finnish bolting the roof back down.cheers again for the guidance