Recent content by round

£140

Egr mapped out and all is well. Boosts much better and more responsive.

After a lucky chat with a mate I have tried a known working maf and the issue returns with that installed and plugged in. Suspect sticking egr now. Will see about getting it mapped out. I hope that solves it otherwise it’s loom failure.

Ok so I blanked off egr no change. I cleaned maf no change I unplugged maf and fault goes away but I have noticed that without the maf plugged in it stops the egr from working too so I suspect it’s still either the maf or egr or maf wiring. I will look at getting egr mapped out to elimate that...

I soaked maf in brake cleaner and flushed out the intercooler which produced alot of crap. Problem still exists Will try new maf and egr next Cheers

The egr readings are always up and down. If I use a plate to blank it off theres no difference. Could the egr itself give off an incorrect signal or affect boost if it sticks open? It only happens after 20mins or so once engine is real warm. I suspect an ele trical item breaking down with heat

What does the pump in the tank do? Fuel pressure dips and raises at the same point but that could be due to less demand.

I have a strange 1 and its driving me insane Freelander 2 07 Car generally runs fine but when warmed up every now and then I get a loss of boost. I have an obd plug and torque app and can see it boost up to 22.5psi most of the time but sometimes it just all of a sudden drops. If I let off the...

I know but apparently there are two kinds and I need the lr number

Does anyone know how to use microcat to convert an engineers number to an lr part number. 6G929F836GF Or 6G92-9F836-GF Apparently it can be done but I can’t seem to figure it out. Cheers

Ok so I had 1 injector rebuilt and I changed the cam position sensor whilst I was there. Seems to be all good now. No smoke on start up and starts on the button. Hopefully it will continue to be fine Cheers

I'm going to get my injectors tested. £17.50 each. Hoping they come out with ease... I suspect fuel is leaking into oil as it seems very thin and a little above level. It doesn't smell of diesel though. I suspect 1 is failing. Whilst they are off to be tested I will rebuild the HPFP anyway as I...

Its under the right side of the inlet manifold on the end of the fuel rail.

I'm having a starting issue and from looking at problems and solutions yours sound like it could be the fuel pressure sensor. Apparently the wiring corrodes. Pull the plug off and take at look at the contact. In some cases people have replaced that section of loom. I'm no expert but an avenue...

This hissing noise from that area at prime. The area looks pretty clean around it so thinking maybe some diesel is squirting out. I will obviously check hoses when removed but I have a seal kit for it anyway so thinking go for it whilst I investigate the hissing sound. What other possibilities?