Recent content by redhotmax
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
R
Hi all,
My 2000 TD5 has developed a definite engine tone change when i depress
the clutch which wasn't noticable untill recently. When the clutch is depressed the engine has a louder normal diesel knock/rattle running sound than when not depressed.
There are no others symptoms - clutch works...
-
R
Hi bggmw,
Did you ever solve your disco problem on this thread as i have what sounds to be the very same probem for the last 9 months now. Spend a lot of money on replacement parts without success.
Best regards
Red
-
R
Can I remove the rocker box lid briefly whilst engine is running to see if i can find which ones are rattling or is oil going to shoot everywhere?
-
R
Yes, i believe so. There is quite a large angle of cam lobe highest surface that the rocker
contacts as it rotates. This was at the point I make the adjustment
-
R
Hi,
Yes, tightened down by hand then backed off one full turn. Clearance does seem a lot though. Should I try 1/2 a turn?
I fitted new o rings and new flat copper washers (LR). Is this the same as a Discovery 2 CDL kit?
Oil level not rising but vehicle is sluggish in low revs
-
R
TD5 year 2000
My Disco is not running too well at the moment so amongst other jobs i decided to renew the injector o rings and copper washers. Not a difficult job i thought. Now wish i hadn't disturbed them. First time i used Britpart parts but the motor then sounded so much louder so on a...
-
R
For a Disco td5 year 2000
Can anyone supply the following please:-
Torque from the big end bearing cap nuts and also
for the sump bolts.
Haven't been able to find torque charts on-line anywhere
and I am in the process of replacing the shells.
Thx in advance
Red.
-
R
Hi All,
Just a reply to close this thread having solved my particular mechanical problem.
I carried out the cleaning of the fuel pump that sits in the tank as suggested by 'thebig lad' on here. It was not a difficult job really, I found the pump (including the mesh filter) to be covered in a...
-
R
Hi Scott,
I am having the exact same symptons with my TD5 at the moment.
Did you solve the problem, and how did you solve it
Best regards
Red.
-
R
Cheers, thebiglad,
A job for this weekend i think.
Red.
-
R
Sorry,
Forgot to mention, new MAF also fitted
Best regards
Red.
-
R
TD5 year 2000
Hi Everyone, Hope you are well.
For a couple of months now I have had an intermittent fault on my Td5.There is a random hesitation/lack of power which i cannot seem to get to the bottom of. It revs fine when stood still, the problem seems to occur when moving, under load i...
-
R
Replace both, If one needs doing the other won't be far behind.
Doddle of a job.
Instructions on here somewhere.
Red.
-
R
Afternoon the all, only me again.
Disco TD5 year 2000 manual.
I may need to replace or rebuilt my engine before long.
Therefore please can anyone tell how I determine whether i have a 10P,
15P or 16P or any other P engine in my Disco. ?
I have been looking on Ebay and now confused.
And...
-
R
Thx sierrafery much appreciated.
regards
Red