Recent content by Quillia

Hope you have recovered from your accident if not wishing you a speedy recovery I have tuned the injector but not adjusted tappets! Lost a bit of acceleration when I changed clutch 2 mths back but I imagine just breaking the clutch in! Will try tappets Thank you

Cheers ne Cheers neilly Will give it a go ! It’s a pig finding a flat hard standing even though gears hold her thank you

Morning Windy, Did you use any tricks that could help with this as cable is correct and once measured against old one it was 2 inches shorter that much it had stretched by but still just worked! I must be missing something Stay well

Good morning kwakerman I have expanded shoes till drum stops then wound off 1.5 turn until drum just moves then tried to take up tension! Is it to with the route of the cable from cab to drum ? Thank you in advance

Any good pointers at tuning for economy would be great as I have have not had to tinker to much under bonnet yet! So a step by step or good site direction most appreciated Salty Regards Quillia

Top of the morning Salty! Thank you for your advice it is good to hear the 2.5 na are still good to go. I have overhauls gearbox and transfer ! Had to replace input gear with cross drilled , new clutch HD! All done with me my wife and good old block and tackle. Just proving the fact that who...

Cheers Paul always good friendlies across the water! Should be good but always remember 6 P’s ( proper planning etc) have given gearbox and transfer box overhaul . It will be a test as she is ex-mil and they always look after their units just sat still over 10 years. Thank you

good morning B I have replaced hand brake cable on 110 2.5 na with an LT230 trans I cannot for the life of me get the new cable to operate properly the slack does not take up/ cannot get it to tension ! I know I am missing something so simple. Any ideas explained in depth gratefully appreciated

good morning LC (landy community) I am off with my wife to France beginning of August even though a lot of work done on 110 2.5 na who ever knows? please give me a shout out if any of you are enroute to my destination in Urciers (Indre) its good to know help is near if needed! Regards Quillia

Good morning James I have a leak on rear output oil seal ! I have changed once even greased it up with vas but still leaked. I inserted it carefully using old seal with soft hammer to depth of previous one but still leaks. Any ideas favoured Regards Quillia

Good morning to the early riser! Could anyone let me know how you tell the true mileage of an ex- mil 110 2.5 na 92’ ? I have superficial rust on body work only 1 gaiter on track rod is showing signs of wear. How high does a speedo go is it 100000 then back to 0? Thank you in advance

Good morning, have a clunk when taking up transmission in gears 1-4 ? Have no apparent problems with gearbox LT77 or transferbox LT230! Have a vibration in steering when cruising at 50 sometimes then nothing. Hardy spicers have no lift in them just some slack on front propshaft/ take up I...

And it cost nothing for that Info x As U r a moderator beasty what can u tell me about front output bearing on 110 2.5 na LT77 gearbox LT230 transfer box! I have at least 1 1/2” backlash when I turn prop as I have a clunk when taking up transmission gears 1-4 not 5th thank you

I have recently used the mod and received info from cold files as the merlin system is not active any more for vehicles demobbed

Cheers RR PROBLEM FIXED brake light feed on trailer loom sheared by rear crossmember up by fuel tank! Cleaned dried mud and found insulation charred and copper on copper cross feeding and interfering with pick-up combined lights. To much expo mayb Regards Quillia