Recent content by pete1987RRC

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. P

    Bolts Missing (various)

    Was it in arkwrights shop
  2. P

    Disco 1 Egr removal, MOT time

    Emissions are such an issue how long will it be before MOT man is instructed to take the cover off as part of the test
  3. P

    Warning M1 & M25 cameras

    Bedfordshire old bill wanted to set theirs at 70 a few years ago but they were over ruled by the cps and its far to close to the calibration of the kit and possibly some speedos Your quite safe at sub 80 on the M1 cameras it appears. 94 mph is the ban poimt
  4. P

    Range rover problem re starting problem

    Clearley not that obvious, lots do it
  5. P

    Range rover problem re starting problem

    Engine cleaning a waste of money
  6. P

    Front parking sensors

    On my 1987 the front sensors just qive a big thud when you get too close
  7. P

    1987 RRC 3.5L efi starting/hunting/hot stall problems

    This also sounds like an air issue, check all the pipes om the plenum, they can come off all on thier own and take the pipe afm to plenum off and check for holes and to see if ots collapsed. Does ypur motor have the 9th injector l/h side of thw plenum.
  8. P

    RRC '92 - Electric seat blocked

    I have 2 toasted ones, i do believe they also get eaten but the battery but mine are all toast! Toasted at the relays
  9. P

    RRC '92 - Electric seat blocked

    Not sure if you can fit a manual seat? May be hard to find in the right trim. The ecus are very different and you cant swap them over, are your mirror adjusters workimg also as they are also controlled by the ecu. If you can figure the plugs out you could try a live supply going to the correct...
  10. P

    RRC '92 - Electric seat blocked

    Yes ypu can but its slow. Disconnect the drives at the motor and spin with a drill. BEt your ecu is toast
  11. P

    Classic I am thinking of buing this one...what are your thoughts?

    Thats a lot of brass for an old motor! Go pver it looking for holes in sills, inner wings, wheel arches
  12. P

    Ignition unit

    Is the starter relay working
  13. P

    Other Condolences

    +1 A very difficult time for any family, i hope there is a light at the end of your tunnel soon
  14. P

    Early 3.5 flapper EFI injector issue

    Them ECUs are getting old now and depending on age so is the efi loom so double check all the cable and connectors as the wire on the early ones is so fragile! A spare ecu is a good idea as you can swap out as a fault finder. I have flapper ecus but in the midlands. All the ecus suffer with...
  15. P

    Rust on rear NAS step

    Ide get them off the floor before her indoors clocks what you are upto
Back
Top