Recent content by mikeyt

I got a pair of these for mine Welcome - A. M. A. Services Was a bit worried about fit but they fit spot on and a lot better in my opinion. never rust wont dent or break easily and everything bolts straight in. But a bit pricier.

my record is 4 hours including changing the spigot bush and strengthening the release fork on a 300 disco :D

With a part like a clutch i would go branded every time and not worry about poss hassle in the future. ap driveline for me in the landys i have done clutches in.

Some solid advice there, id go for a decent name second hand welder rarther than a new clarke etc....

Ive found the new teflon ones to be a very hard material that dosnt like to be machined and picks up, all older ones I have machined have seemed to be a lot more machinable. Which out of the two is a better material for the swivels i do not know

Mill dan mill lol I decided to slot the swivels and drill and tap a extra hole for location rather than cut and weld the axle as I was a little concerned about the haz with welding and the axle fracturing around the weld but im sure with sleeving it would be fine.... I have made a jig for the...

Impressed with the neatness of your fuel and power line fitting must be down to the bolt layout ;)

Dan had it sand blasted after the chassis was modified and then straight to galving after drain holes were drilled to let the air out during galving. they do do a acid dip/clean and then into a stabilizer as part of the dipping process, but they wont take one in covered in paint rust and waxoil...

You would be looking at change from £300 for sand blasting and galving

These were threaded compression ends with a olive. more expensive than crimp on ends but with the benefit of having a roll of hose and making them custom length to suit the job without having to fork out on a crimper.

Sorry for the back to front pics lol wernt really with it after a 20h day lol. Was like a zombie at work today lol but got it done so can crack on tomorrow. Body can be tightened down it all mounted but only nipped up with the ratchet, while I was checking alinement. Think the rad bottle will...

Worked on dans truck to the wee hours and finally realised it was time to go home when I suddenly noticed myself singing a song to myself that I made up about rivnuts.... I don't have it in me to write a caption for the pics but I'm sure dan will add something if needs be...

Hey leave me outa this lol he asked for 200 lights I'm just doing what is asked for lol

lmao sounds more like it, not really liking the build by the way...poor bloke must be drained of all sanity by now....

With a bead roller..