Recent content by mandythelandy

replacing UJs is cheap and easy and will sort out the play in the propshaft. However, you are most likely looking at transfer box refurb or replacement to eliminate the play in it. Mine has about an inch of play and every time I engage gear i get a loud 'click'; im just gonna run it till it dies...

I think I have a complete top assembly for a LT77 box which should do you a turn if thats what you got. Let me know if you want it: [email protected]

What age is the 90? If its pre-300tdi you wont fit the rangey wheels on the front as the hubs are too big. You need to change the axle, or rebuild each end using younger age hubs.

I have disco axles available, 200Tdi. Sell you the pair including diffs for £175, or £100 without diffs. Truck has done 180k miles. Axles in good nic, never been offroaded. Im in hampshire near Marwell Zoo.

From memory: pozi screwdriver to take off gaiter on handbrake handle (step 1); size 13mm spanners to remove nut and bolt holding cable to handle (Step 2); snips to remove split pin on other end of cable (drum end); size 19mm/17mm? spanner to under nuts clamping cable in place on fixed bracket...

Nice and easy. Any LR dealer will carry cable, Paddocks stock for definate. I did my 90 cable in under an hour, and just over an hour for the 110. That included taking out seat/cubbie box.

Not got round to checking for split hoses (just been reading up on that across google!). The screech is quite metallic sounding, yes. Positive i have connected oil pipes fine both at the block and at turbo unit. If the turbine is not getting that film of oil, any way for me to chuck some in...

(200Tdi) Just changed my 110's turbo to the one of my 90 (which was a really good unit before engine caught fire some time earlier in the summer). The old unit had no power at all, and the replacement unit now does have decent amount of power but at the cost of a really loud screeching...

I have a couple of 200Tdi power steering pumps available if you are interested: [email protected] or 07825 095207 Chris

Anyone fitted rangerover front and rear seats in a 110 before? Ive got my eye on a set of leathers out of a vogue SE (1980 something vehicle) and would like to put them in the wifes 110. Ta

When I did the head gasket, checked all rods and valves, decoked head too.

:confused: :confused: Ive got major headache with my 200tdi. Just replaced timing belt as snapped. Reset the injection timing as it should be, lined up the crankshaft and camshaft as they should be, per Land Rover workshop manual. When put bakc together it will just about start after a couple of...