Recent content by Longhairedlegend
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
she now tells me it’s actually less than
ah right, do you know where I could get one from, and are they easy to plumb in?
-
Right, onto the next possible issue. The temperature gauge sits around 1/4 when running, but won’t go much higher. Is it supposed to be that low?
I did find another post on this but the answers varied and the thread became somewhat of a royal rumble.
-
The new pitch mount arrived today, after some fettling with the position of the engine it’s finally on! I’ve just taken my son for a quick drive around the block and all seems well
Thanks for all the help guys, you’re all legends
-
Boom! It’s off. I’ve had to try and straighten my 15mm spanner though
-
I haven’t encountered bolts this tight since me and my mate rebuilt my engine some years back. He had a breaker bar with a metal pipe on it, with his full 15st body weight on it. When it finally went, he smashed his knee on the ground. I don’t have a picture of that stage, this one is just...
-
I’ll try a half inch ratchet with a 15mm socket, I’ll push it with my foot. If that doesn’t work, I’m getting a breaker bar today, hopefully that’ll get it off
-
I’ve put about that much in I think.
Just trying to remove the one remaining bolt for the pitch mount. Are they reverse thread?!?! This thing is tight as hell and the Milwaukee impact gun won’t even touch it!
-
I packed a bit in, and covered the bearings. I’ll maybe take the gaiter off and pack a little bit more in. Thanks.
-
Do you how much grease do it put in tripod hub bearing? I put a little bit in and coated the bearings last time. I know too much can be just as bad as too little, but I can’t find a definitive answer anywhere
-
Just to be safe, I’ve ordered a new one, cheers
-
It’s still there. Are these known to come loose?
-
I believe I’ve found the offending article just now
-
My new prop cv kit arrived today, however it’s appears to be missing one piece, I’ve circled it and contacted the place I bought it from. I’m assuming it’s to stop the tripod hub from eating the rubber gaiter
-
Thanks, I have looked at the one wheel up test. I’m going to do it when I get a few minutes. It’s on axl stands at the moment so I’ll have to drop it down.
-
Is it true the viscous coupling has a lifespan of only 70,000 miles? Ours is on 89,000