Recent content by LandySurf
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Thanks Kev, that’s a good shout. Could this have happened with the rear crossmember replacement too? The timing of things is just strange!
-
Thank you so much for the advice above!
Really do appreciate it and it's a great list to go off.
Could some of the things on that list been caused theoretically by the removal / replacement of the rear cross member when they stripped off the old one and put the new one on?
Would they have had...
-
Hi All
Need a bit of Landy Zone therapy with any thoughts / suggestions you might have.
TD5 90 - Short Wheel Base / 2003
Just came back from service and MOT last week and rather a large bill including new rear crossmember.
Today as I was driving, coming to a halt at the traffic lights and...
-
Just wanted to say thanks to everyone who commented above and for the latest replies! It’s always great to have advice from those who have ‘been there’ and ‘tried it’ - so just wanted to say it’s been very gratefully appreciated!
Got the confidence now to give it a go and see how I get on so...
-
Bonda Primer! Got it - have just found a litre of it on Amazon! Great stuff. 2 or 3 coats of that so that’s the Primer sorted!
I think from there with the top coat, we’ll go with a couple of coats of Hammerite just for decoration purposes 😂 I’ll grab the matte one that’s got the primer in it as...
-
Thanks for this and you did a really great job!
Seems like there is another vote there for Bonds Primer.
If i was to use Bonds for a couple of coats - which hammerite would you use to paint on?
Would it still be the direct to rust one that says it's got primer in it? Would that one be ok to...
-
Would you say there is any advantage to using primer and then painting - over using something like Hammerite?
-
It's pretty rusty and looking quite awful! I know it's one of those things that i'm going to have to do quite frequently before replacing it as it's near the end of its life - its just to take the eyes off it a little!
Direct to metal paint sounds good - I've heard of quite a few people using...
-
Hey all
Looking to paint the rear crossmember at the weekend to spruce things up a little bit!
I don't want to spray it - i'd rather paint it by hand - just personal preference
Yes i know it's easier to spray - more time effective - etc - but just personal preference to paint by hand ...
-
This is a great suggestion!! Thank you! 👌
-
-
Hi all
Looking at some hacks for keeping the driveway clear of oil on my 90.
I was wondering if any of you put anything down on the driveway after you park up - to act as barrier for the oil?
( I know it's a faff - but 5 extra min putting something in place is alot better than a woman scorned...
-
No different one! Have popped you a DM
-
Understood - thank you! How do you get it to just allow that last bit of air out? Is it easily accessible so I know what I’m looking for?
Is it accessible from the engine bay or underneath? So sorry as very much a beginner on this!
-
I’m just about to order ATF - ( good old Amazon Prime ) - does anyone have any recommendations? Have attached some pictures of the ones I’ve found!