Recent content by Jud1

Hi nodge68 rac came and looked at the car started it put scan tool I asked for fuel pressure readings he said the car has started so pressure should be ok these are the codes he got dtc:1613 cylinder balance control Dtc:0202 cylinder 2 injector circuit Dtc: 1e25 camshaft position sensor Any...

Thanks nodge68 for your reply I have just managed to start it with easystart and idle isn’t to bad but when you try to Rev it it’s very lumpy as if it is only running on three cylinders here is the images from live data I’m not to good with this stuff and help will be gratefully appreciated

Thankyou for your reply 4nee4bee the only problem is the car won’t start will live data be any good on a stationary car or does it need to be moving and running

Hi codpiece could you tell me how you diognosed that the lp pump wasn’t pumping fuel please

Hi codpiece my brother inlaw has an 05 facelift model and has exactly the same issue he has been driving with no issues and then last week he took it out and on the return journey the car started running really rough like only on 3 cylinders upon turning off the car and restarting it really...

Hi everyone thanks for all the help I have just turned ignition on and lp pump seems to be running as it should and cuts out after a short while which I think it is supposed to do tried starting it again and the car seems like it was going to fire up but dosnt when it did eventually fire up...

Thanks for all the replies guys

Hi Andy which fuel pump would f10 be for low or high pressure one or does it supply both thanks for your reply

Thankyou for your reply Andy it’s much appreciated

Thank you nodge68 for all your info you are very knowledgeable I have seen another post relating to the o rings on the hp fuel regulator splitting could this be another possibility also how do I do a leak back test on the injectors to see if he might a a leaky injector or two

Thanks nodge68 if this is the fault would this not present any fault codes also would you be able to tell me the process of draining the sedimenter please thanks for all your help

Thankyou nodge68 to here the pump running does the car need to be running or will you here it just by switching the ignition on as the car won’t start also what is the procedure of draining the sedementer I’m no mechanic I’m trying to help out my brother in law

Thankyou nodge68 for your reply I only have a cheap code reader and have no live data I think I may have to call the aa so they can put there machine on it I looked on here and tried a few things that I found ie the fuel pressure sensor and also the harness tried unplugging that but no change...

Hi everyone can anyone help I have an 05 freelander td4 all was fine when I drove the car in the morning then on the way back the car lost power and idles really rough and now having trouble starting it the Emil is on but there are no stored codes so a bit puzzled to what is wrong any help would...

Thankyou for your reply how do you get the cable hooked back on the mechanism at the bonnet end as you can’t access it or is it a matter of removing the front bumper to gain access as the slam panel appears to be double thickness and the cable runs in between them many thanks