Recent content by goetz74

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. G

    clutch release point

    Hi, after changing my clutch master and slave cylinder i adjust my clutch like workshop manual. My question , the clutch pedal was pressed and open/release 4cm before the pedal hits the floor. Is this ok or not? Best
  2. G

    R380 input shaft stuck

    Hi, after changing my clutch at my 300 tdi, the input shaft maybe at the clutch splines , i torqued some bolts from the gearbox bell housing to enginge and dont realised that the shaft slipped in. I greased it with some copper grease. After loosen bolts and spin a bit the crankshaft bolt it...
  3. G

    Weld Seam chassis gearbox crossmember

    I Posted pictures above
  4. G

    Weld Seam chassis gearbox crossmember

    I know what you mean , dont know if the gap was big enough but at my endoscope Camera it Looks like Metall Melt through the gap. If Not only Option cut out and Weld again?
  5. G

    Weld Seam chassis gearbox crossmember

    I grind the rust down before welding, Not shown in pictures
  6. G

    Weld Seam chassis gearbox crossmember

    Hi , i cut out and Made a fitting steel , and welded in, no idea if i Burned deep enough. At Last i Grinded the Weld down
  7. G

    Weld Seam chassis gearbox crossmember

    Hi there, any thoughts about this Partial Welded Piece and the Weld Seam , reweld Or leave it as it is ?
  8. G

    Automec brake pipe kit

    Hi, i get the brake pipe for my tdi 130 rear from automec, why they used double flare type and no bubble at the end to the connector?
See more
Back
Top