Recent content by Gary East-Yorks

Thanks for the reply, is there a circuit diagram on those relays to identify the pins .

Hello folks please can anyone identify the 4 wires of the fuel tank pump plug, i want to test if i have power to the pump as i have no fuel to the under bonnet filter housing and cant hear the pump running. regards Gary

Thanks for your replies folks, these are the originals, i will change them.

Hi all, both my front radius arms sit slightly to one side between the axle brackets although the rubbers look good and centrally pressed in and the tube inserts look to be still bonded, both are slightly towards the centre of the axle, I'm obviously presuming they would have been central in the...

Well folks, bit of a mystery this one, i removed the inlet pipe to the fuel filter housing and cranked the engine but i didn't any fuel from the tank. i will add that as the vehicle is stood for long periods i do remove the battery lead, i had a thought and locked the vehicle with the key in...

Thanks for the response, its a 1995 model, i will try both options.

Hi all, My usually good starter is refusing to fire up , recent new battery so spinning over nicely but no attempt to fire. Clear fuel pipe to injector pump has a big air bubble. Am i right in thinking to prove fuel is getting to the pump that if i remove the clear fuel pipe into injector...

Thanks Wammers

the injector nearest the bulkhead is leaking diesel through a split in a rubber cap over its unused spill port. Are these caps available or has anyone used something else.

I run my 18inch Goodyear wranglers at 28 front and rear because i know it wears the centre of the rears if any harder.Been there.

Just thought i would let you all know i re taxed the sorn vehicle online today for the 1st april and all went ok using the number from the v5 and i got the e mail back to confirm all done. Thanks for your help guys.

Thanks Jonnytd4 and Wammers

I have got the mot and insurance renewed just need to tax it. have been advised to go to my post office with the v5 is this correct as my local post office love to disappoint me.

Thanks Wammers.

Do i need to remove the camshaft cover to get the camshaft front cover off to replace the o ring seal. Taken the two studs out but plate rocks about not wanting to come out and did not want to force it. (this is the round plate with two bolt fixing just above the thermostat housing ).