Freddie17's latest activity

Thanks mate, I spent weeks procrastinating over this but in the end it was fairly simple to do. DeepSeek did all the heavy lifting for the programming and the Voltage Divider Circuit that senses if the cable was plugged in was also simple in the...

Iffit were a freelander it wooddent of broke'd.

Have you got a LR specific reader on it? I’d check the fuel rail pressure sensor…

Well done - that’s quite some feat

It works 😊 I called into a Tesco in Lisburn Co Antrim today, plugged it in, pressed the charge start button and it started charging straight away👏

Maybe next time

I was tempted to come down in the F2, but have been doing some work on it lately, so wasn’t sure if it would be ready

Believe it or not I have only a couple on the phone. You will have to wait for some others when I get them off the camera. Just the two of us today, a first timer came along in a 200tdi 90, said he enjoyed the day and would come along again...

Ok… pics time… 😁

Closing the loop. For those curious it turned out to be rear main. I purchased a 2.8 seal and installed it and no more leaks.

Didn't know that. I know some cars do both from one set of pads.

Chinese tariffs ?

My old F1 came home for a repair ‘visit’ today. Needed a new rear light lens fitting 🙄

Not noticed any slowness/difference on my iPad. The ‘500’ errors have become less also… Phones use a smaller ‘mobile’ version of the site, dunt they? Maybe that’s where the issue is…

A few years since the last post, and this is my first, but thought it might come in handy. Fitted a reverse camera and screen to my FL2 today. Wasn't keen on removing the boot door liner, partly laziness, and partly didn't trust the plastic clips...

So after a couple of weeks procrastinating I finally made time to try and figure out how to make the charger work at a commercial EVSE which the setup above failed to achieve. It works great at home but commercial chargers require a low...

To solve this and any further high pressure fuelling problems that come my way, I have purchased a 6,000 PSI gauge and an adaptor that will fit into the hp pressure sensor hole. This will allow rail monitoring. If low I can also fit the gauge to...

This was the first production freelander to have coil suspension.

A Ford Coat Hanger might work ...

Indeed such a shame when some convert them to coils as I think it ruins them seeing the air suspension offers such fantastic ride quality Of course understand it’s all down to personal choice , just mentioned that I felt daunted at first but...

Hiya Funny enough I noticed that as well when I was looking for one It was the same when I finally bought my D3 as it was like a boat , then after I virtually rebuilt the suspension and got it perfect the difference was like night and day All...