Recent content by eric sainz

Fabulous . thanks again

Thanks a mil

Hi same old story 2000 disco 2 3 amigos even with brand new shuttle valve and plan b in place I have also changed to a slabs ecu from a 2003 now . I erase faults and abs light goes off but TC and downhill decent stay on . Over time abs light comes back and hawkeye point to shuttle valve fault...

Hi , I m still trying to figure out TC , ABC problems , now I found a new one , when the truck isn t moving I can read live values in slabs ecu with hawkeye but when I try reading while truck moving it only takes a few seconds to disconnet screen saying no connection etc. I wonder if anyone...

Thank you

Hi , I took these reading after changing ACE ECU and bridging solenoid 14 , DVC 0.01 Amps both, pressure control valve 0.00 amps , pressure sensor 143.60 bars, residual pressure 20 b , system pressure 130.75 b , accelerometers upper 0.00g and lower 0.02 g . I wonder what you make of this ...

Will do thank you

My mistake now that I read live data from slabs ecu it show 0.0 while opening throttle. It doesn't move. Does it corroborate a bad slabs ecu or trouble at throttle?

Yes I ve heard about 2 , 3 track but I wonder if hawkeye is capable to allow me to manipulate this . What I have seeing is that if I press throttle % values go up . Any ideas?

Im not sure the donor was good I opened it and didn t look as if it had water ingress etc . Now the original one was reporting 3 amigos and haweye indicated historical shuttle valve etc. Although I had replace the entire unit including a new shuttle valve and also grounded it plan "B" so now I...

I have swaped to the 00150 , I ll recheck connectors. Thank you

2000 disco with D1 CLD shifter , I changed the SLABS ECU from a 2003 donor result is TC and HDC lights stay on, hawkeye tells me " failure of throttle position signal". I read somewhere that my engine ECU needs to sync with SLABS. I only have a hawkeye and no dealer to reprogram . If...

HAPPY CHRISTMAS TO ALL!

Got it Thanks again

Thank you!!