Recent content by dom-g60
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
D
Hi all have done a search but not revealed what I'm after. Can anyone confirm the thread size of the the tappet adjustment screw on a 200tdi? Is it m8x1.0 metric fine
Thanks for your help dom
-
D
thats what i thought do new rings come with oil scraper/controll rings
-
D
Bores measured with an internal stick micrometer and piston ring gap measured using feeler guages. Most wear is side to side like you said and nearer the top
-
D
Hi guys have just stripped my series 3 2.25 diesel due to lots of blue smoke. Mic'd up the bores and put the rings in them to check the gap in the butts which is massive ie (0.120'') when in should be (0.014''-0.019''). The bore measurements are all fine only showing about 0.002'' wear off the...
-
D
All ordered. Didnt notice any thing but then im only moving it around the drive and garage so havent been on the road yet
-
D
ok thanks so it 3rd and 4th snychro hub spring?
-
-
-
D
transfer box cover seal is the rectangular cork one. did look at my haynes manual and it looks like the item 35 (clutch detent spring)
-
D
Hi guys I've just changed the transfer box cover seal and refilled with oil on my 1983 swb series 3 2.25 deisel and then went on to do the gear oil. As i removed the drain plug 4 thin strips of metal fell out it looks like they have snapped in half, 2 of which have a slight shiny groove in them...
-
D
Sweet cheers guys around what I thought it would be
-
D
Hi all I have a 1983 2.25 diesel series 3 which I have just restored ready for mot and I was just curious as to what the road tax would be have tried looking but had no joy would appreciate any help cheers
-
D
Got some slight rot where the bulkhead bolts through the chassis with the long bolts. Have replaced the bolts and one outrigger was just wondering how important the condition of the bulkhead fixing point is for the MOT. Thanks for any help And comments
-
D
Hi all im new to the 4x4 scene and have acquired a series 3 SWB cheap of a friend.
Have started doing the required restoration work which has included a full break overhaul.The drums were ok so i have replace all wheel cylinders and shoes, new seal kit in the master cylinder as the cylinder...
-
D
Hi all im new to the 4x4 scene and have acquired a series 3 SWB cheap of a friend.
Have started doing the required restoration work which has included a full break overhaul.The drums were ok so i have replace all wheel cylinders and shoes, new seal kit in the master cylinder as the cylinder...