Recent content by DiscoNickY
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Is it Kawasaki green that mate? Going to pick a 90 up and start a rebuild an was thinkin of going for the same green u used.
-
So u can cut sill away without touching the floor? Did u make new body mounts/outriggers? Bet ur missus is made up with the mess uve made of that path! Haha
-
Need to do to OSR arch myself and sill... Very soon!! Any other pics of progression of the job?
-
No mate. 24. Late 200. Bit of a mungrel. Mish mash of 200 and 300 bits.
-
Never been Bala before. Not much deep water is there. I've had my fill of ridiculously deep water now anyway. Think I'll steer clear of it. Haha. Sure there'll still be more breakages tho.
-
Brilliant. Cheers fellas. Off to Bala p&p this weekend so need to get It sorted ASAP.
-
Cheers mate. So how do I access this wiper motor? Engine bay or in car?
-
Nightmare of a place. Won't be goin again. Another problem that has arose is the rating the temperature adjuster had just gone slack and it's stuck on cold!?!?
-
Could it be a flooded relay that's packed in? Anybody know which relay is for wipers?
-
Electrical problem now mate. Went through rather deep water at hill and ditch on weekend. Now the wipers will not stop!!!!! Help please.
-
That's all I'm after the stubby. Ill use original front section in stainless and make a little middle section up with a cherry bomb in with tht stubby on end. That's the plan anyway.
-
Where did u get exhaust from mate?
-
-
Ok. Cheers guys. It's got 2" on springs an 2" spacers. Was just thinking of replacing spacers with 1" because to be honey the spring doesn't sit completely flat in seat the front is raised which would mean the axel still isn't sitting flat even with 6 degree castors so an inch drop might sit better.
-
Ello noisy. Quick question to run by u mate. I've got a 4" lift on mine with the 6degree cranked arms but the high lift is putting too much strain on uj's an output shaft bearings etc so I wanted to drop it an inch or two but obviously don't want to fork out for the 3degree cranked arms. Would...