Recent content by DanTheDefenderMan
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Hi guys
just a quick one. whats the correct procedure in changing the 90's colour. ive been thinking gun metal grey instead of keswick green thats currently on.
do i just get it sprayed the send a change of request to swansea and wait for the dvla to come out to inspect it?
or is there...
-
take the binacle off the dash. unscrew the block where the indicator bulb sits.
unplug the indicator bulb from behind the dash (should be a back housing at the back that just turns off)
screw the dash binnacle back in and your done :)
happened to be on my old landy. 100% will fix the issue...
-
-
https://www.gumtree.com/p/land-rover/defender-300tdi-conversion-mint-/1202350371
Just stuck it on gumtree. From Lancashire pal
Have to be quick it's been very popular on gumteee
-
on the switch behind the binnacle there is 3 wires going into the switch. two at the bottom and one at the top. is that right or should it have an oath to it also?
-
hmmm i'll check the 60amp fuse but i doubt its that ha!
yea that's my location but its well off the beaten track and i've got plenty protection around the farm :)
-
Hi guys
So last night I was using my heater and was nice and toasty. Today it's not working ha!
Here's where I'm up to. I've checked the fuse near the gear stick all seems ok. I've ran a positive from the battery to the wire just before it goes into the riveted box and the motor is 100%...
-
-
-
have a look at the braided pipe on the top of the engine going into the injectors. this was the problem with mine. replaced them all with new and it fired up first time.
there was air getting in as the pipes where corroded.
-
Hi guys
just a quick one. my drivers door must have fell slightly and now is not closing flush at all.
must be at leas 1 inch gap where the seals are. ive took the striker off and repositioned in numerous times with no sucess. is there an easier way to align this door?
it seems to me as...
-
if i just buy a compressor which is the best to buy a 50L one? and a gravity fed spray gun?
-
back to the question in hand guys, whats best colour to go on by hand?
-
600 is just an outside spray and I don't have much faith in the sprayer either ha! Just wanted to do it my self. What colour does go on well with roller by hand? It's green at the moment
-
so that would need to be done in a spray booth etc... ?
or can i roller a top coat lacquer on?