Recent content by crowelander98

drill and tap the centre of it using a left hnd thread tap,screw in a left hand set screw bolt and it may unscrew on its original thread. Prob best to spray it with wd a few times and best if engine hot when you go for the unscrew. alternatively a similar approach would be a stud extractor.

I had same problem on mine and by the way sorry to hear about your probs bikertanz, hope you get dog back! I couldn't get mine to re set either and i eventually found that it was working opposite to what it was meant to so i swapped + and - on motor inside tailgate, re set and hey presto it...

Let us know if it does correct it or not. Lots of peeps having issues with 3 amigos myself included!!!

There will be more to come!!!

i'll do an ecu clear/reset and if that fails i'll stick a standard replacement switch in for brakes. It may also spontaneously combust at the side of bloody road!!!

Hmm, i've just sent new switch back cos mine only has 2 wires going to it and they jus plain old spade connectors (original, not tampered with)and new with harness adaptor is 3 wires and would just not connect in. i'm mechanical not electrical so no idea if it would work or should i just buy a...

Cheers Hippo, Unfortunately thats not the same switch that i've got that he's changing, think i've got the very first on. It only has 2 spade connectors onto it and no intermediate plug, my wiring comes from switch straight into loom.

Bl**dy switch arrived today and its wrong one! For some reason i'd convinced myself it was an upgraded unit with modified harness but now realise that all i can do is swap existing with a new one. its a 1998 1.8i SW. The switch is P/No xkb100080L, is it possible this could still be cause of...

Hi Guys, Just a brain pick in the hope someone has experienced this one. Usuall story, intermittant 3 lights on dash, then on constant. Then MOT - Fail for the ABS lights. Found Reluctor ring u/s on front drive side and sensor resitance nil, replaced CV and sensor, and all reading etc fine now...

Could always ignore it, Turn up music? Contact Swan Vesta or BlueBells for a permanent fix :doh:

Or try writin Hammaz n Spannaz on the **** house door?

I'm in the middle of replacing clutch on mine, 98r 1.8i, i replaced the hydraulics and bracket about 5 weeks ago, this did help my gears problem but it came back! clutch out today and its like new all bar 2 strips of unidentified steel jammed insed fingers and release bearing. Any how,think my...

Hey all, Just removed clutch and hey presto, nothing wrong with it!!!!! Release arm was pretty much seized and i found 2 alien metal parts, one inside clutch unit and the other jammed behind release bearing. I can only assume that release arm was the cause. Tempted to just refit the same clutch...

Recently renewed slave and master cylinders as i was struggling to get gears and at one point got stranded for several hours unable to get into any gear with engine running. This at the time seemed to cure the problem but now its back and only just managed to get her home yesterday. I'm just...

Too good to be true, think clutch is the problem. Hydraulics helped but problem has returned! I'm gonna change clutch, new one ordered!!