Recent content by Courageous

Well blow me! I did as ya said Batts and during the period of 5 minutes instead of goin for a cuppa I used the time to check the fuses in the engine bay and you guessed it! One of them was blown. Replaced that and the alarm sprung to life and the car started as normal. Talk about Bizarre...

Hmmmmm something else to bear in mind. Thanx. :eek:

Thanx for that link Battenberg. Yes its pretty much what he tried early on but got no response aurally. Of course he hadn't tried your original suggestion at that time. My hope is of course, that your IDM and BCC reset procedure will facilitate the further step (EKA reset). Fingers crossed.......

Thanx - familiar with that requirement but so far its not been possible as I mentioned when I refer to resetting the immo. Battenberg, is it likely that I will see a change to this after using your procedure mentioned above as at this time there is no horn at all when the key is turned in the...

Brilliant sir! Thanx for the advice. I am still in blighty but I shall be sure to try this when I return on Weds. Again, many thanx for this and also the good luck wish.

Ok, I pussyfooted around this asking for titbits and now managed to get hold of a haynes manual which doesn't look like its going to help too much so here goes: I was brought in to help with this issue some time after the start so I cannot clarify whether somebody did something proper klever...

Hi and yes its the latter and almost surely immo related which is why I should like to bypass it. I have managed to do the simple bit and get a feed to the starter solenoid but I'm assuming its only the fuel I need to supply now and need advice on this side oof things. Thanx

Just looking for confirmation I suppose that this giant Rolo is the device I need to provide a feed to in order to allow fuel into the engine when the immo says "no".......

Thanx JS. I wonder can anyone else help with this at all?

Ok thanx and are my assumptions correct would you know? Need a good car thief that's what we need! He'd have it away in minutes.......

Ah! Ok so is it actually mounted on the engine or just kinda hanging off it in some way? Is it easy to access? Am I correct in assuming that I just need to give this a switched feed and along with the starter solenoid and all should be ok? I'm concerned as I am reading bits on the internet that...

Ah! Blow it! This doesn't happen to double as the shutoff does it? I need to find this as a part of the process for overriding the immo. Looks like the immo has packed in and we just can't start the thing. The feed to starter solenoid is the easy bit. I'm guessing the only other interface that...

Hi chaps, following on from an earlier thread can anyone identify this for me please? On the offside of the engine at the rear of the block there is something with steel pipes going into/out of and also a plug with 2 wires on it. Can anyone help me? I am hoping that these 2 wires are a...

Oim t'inkin it was a heinz manuel he was offerin' me'self! Ya can't beat a point of guinness fer feckin up a good converstaion can ya? Hehe!

......... Err no! Enjoy your bath!