Recent content by charloa2005
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
C
Problem solved. It was the HP pump. It seems that the shaft had sheared as it turns freely by hand. Swapped the pump and ...vroom!
-
C
Thanks for all the replies.Replaced the under wheel arch pump and it has not changed anything. Next step I will replace the high pressure pump as it seems that its not pumping the pressure needed for starting. I have read that if the common rail pressure is not sufficient, current will not flow...
-
C
Have you resolved the issue?? I have exactly the same symptoms, I have not traced the fault yet.
Regards
-
C
Thanks for the info. So its better to pull out the injectors and check....
-
C
Changed the hp fuel pressor regulator.....no luck neighter. Still no current to injectors.
-
C
charloa2005Member
My Freelander 2004 Td4 lately had experienced lack of power with the engine light comes on after passing 2500 - 3000 rpm. I decided to clean the maf sensor with brake cleaner. When I had started the engine, it went high revs upon start up and I switched off the engine and took...
-
C
charloa2005Member
My Freelander 2004 Td4 lately had experienced lack of power with the engine light comes on after passing 2500 - 3000 rpm. I decided to clean the maf sensor with brake cleaner. When I had started the engine, it went high revs upon start up and I switched off the engine and took...
-
C
charloa2005Member
My Freelander 2004 Td4 lately had experienced lack of power with the engine light comes on after passing 2500 - 3000 rpm. I decided to clean the maf sensor with brake cleaner. When I had started the engine, it went high revs upon start up and I switched off the engine and took...
-
C
Crank and cam sensors both tested satisfactory. Still no luck. No current to injectors.....
-
C
0 pressure although the common rail is pressurized.Swapped the fuel sensor, no luck.
-
C
Have you solved the problem.?? I have the same issue.
-
C
Computer saying no pressure in common rail, although its pressurized. Will change the Fuel flow sensor to see if the beast will start!!
-
C
Update. Fuel pressure sensor is showing 0 and common rail is pressurized with diesel. Still no voltage on the injectors.
-
C
Yes. When I started the engine, it revved up and I switched the key off and out of the barrel. The revs went down and engine stopped about 10-15 sec. Tried to start it . Nothing......
-
C
My Freelander 2004 Td4 lately had experienced lack of power with the engine light comes on after passing 2500 - 3000 rpm. I decided to clean the maf sensor with brake cleaner. When I had started the engine, it went high revs upon start up and I switched off the engine and took the key out of the...