Recent content by Ant58

Hi There,ive tried that but it still remains lower than the other wheels.when I took it for a drive afterwards the air suspension fault light came on again .the fault was can bus fault and articulation validity fault. all four wheels have had new height sensors fitted last week Today Saturday...

done all that's listed above,but front left side stays lower than the other 3 sides.when youlift it up to max height they all move up in about 15 secs to correct level but when lowered back to normal ride height the front left goes back to lower position.any suggestions please.

Ok, so take measurements from bottom of rim to centre of wheel arch.put measurements onto write in the ASU calibration on all coms software. Don't sit in car when doing this and ECU should calibrate the correct heights from measurement entered.

started car and ran for 10 minutes this morning took the measurements on all 4 wheels from bottom of wheel rim to centre of wheel arch. put those measurements into all coms ASU calibrations and pressed write.The suspension went up very high at the back ( about 10 inches from top of tyre to...

no I didn't,i got the message after stopping the calibration and checked for faults again. ive ordered a compressor kit to check when fitted if this makes a difference. I cant hear the compressor kicking in any more

Ive done the calibration as previous suggestion and the car lifted up on all sides except FL which raised a little then I got message reservoir pressure static when filling

Thankyou for advice ,I'll give it another go!!

hi Thanks ,ive watched video ,ok my car is sitting so low on the right side,can you make a big change to the calibration in one go or must you do it in small increments?

Hi there just got my 4 sensors changed today on 2004 diesel l322 ,when plugged in to allcoms (latest version) got current readings as follows FL 460 FR150 RL 410 RR260, when I try to write new heights I get a fault reading. is this because the readings are so far out.i thought the readings...

front readins are LF 460 RF 150 LR 410 RR260

just changed all 4 ride sensors and car is on the floor. does anyone know how to reset using all coms 4. thanks

thanks for that, I thought I was,problem solved Storey Wilson contacted me and gave me a new download and now the fatboy is sitting straight Happy days

Thanks for all your help Mike. Regards Anthony

not yet,im trying to find correct drivers first. I know my operating system is 10.the computer I took the software from was windows 8

No ,do the driver have to be windows 10 because I think they are for windows 8 how can you check?