Recent content by al-balushi
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
A
Hi
have removed cylinder head yesterday and found burnt valve :doh:
no damage to engine block, do you think i can get away with cleaning piston or should i replace with new
cheers
-
A
hi, done Valve clearances and it sounded a little bit better but still misfire on cylinder No 3. Sorry didn't remove vac pump but found good vacuum when removed pipe and no signs for oil also because knocks aren't my concern.
Took it to mechanics today, lots of white smoke, they both think...
-
A
will check tonight and let you know thanks
-
A
hi, thanks for your reply, How can I check full stroke on pushrod, Could you explain how to check vac pump? I pressed on brake pedal then started engine and pedal traveled about two to three inches
thank you again
.
-
A
hi, having aloud noise coming from engine. I have cracked each injector open and found number 3 made no difference, So removed glow plug and found it oily . Suspected injector to be faulty and swapped injector 3 with 1 and tested again by cracking injector pipe and problem didn't move with...
-
A
by the way how about buy a second hand diff :D if its bothering you that much
-
A
I have never replaced a diff pan but if i was going to do this then i would cut the old pan with grinder !!! welding the new pan is not the problem but try to clean inside diff casing :rolleyes: you could imagine :eek:
I would say try to patch it.
-
A
hi you could get a stud extractors or an easy out set but bare in mind still need to drill with easy out !!!
I could lend you a set if you live near by.
-
A
hi ,, there try changing gearbox oil it might help :) don't forget to take a short drive get it worm
-
A
correct me if i am wrong, i thought interior changed on 300 and for a 200 they sell an extension to hide the extra bit that shows
-
A
i have 200tdi disco (no EGR), cleaned my intercooler three months ago and it was full of gunk i put that to split in hose :)