Hi, my defender td5 2002 90 struggles on acceleration and its hard to get it above 65
Just trying to figure out why at first the E pin on the boost waste gate was misidentified so i thought it could be that but that hasn’t changed anything so iv...
Use some brake cleaner to clean off the split fuel, then run the engine and confirm where the leak is coming from, then take a pic and show us where it is leaking from.
If is is the main body o ring leaking, it is a 10 quid part, if the pump...
I need to replace the rear brake pads on my 1989 90 but it's had a Disco rear axle fitted at some point in its life so not sure which pads to go for any pointers, picture s of pad and caliper below
BOSCH PSS 250 AE 3.6" ELECTRIC ORBITAL SANDER 230V (2472C)
4.5 out of 5 stars, average rating value. Read 2 Reviews. Same page link.
4.5
(2)
Write a review
Ask a question
Powerful orbital sander with powerful 250W motor offers smooth...
Hi, anybody have any ideas please?
2016 Discovery Sport, when I drive car locks no issues, park up, lock it alarm goes off. Had a new battery fitted, if I check the last alarm message - Volumetric sensor.
I can drive for 2 hours, park up...
The bulb is no 15 and you might be able to measure continuity across the thin wires at ballast resistor to see if it’s blown, have you the original wired in series pigtails or newer parallel heater plugs
On @Hippo scroofix link, click on the specifications box. At the bottom of the spec page, there's a download for the user manual. Its in there somewhere.
Ok, tonight's dumbo question.
Brushless,
replaceable brushes,
non- replaceable brushes.
How can you tell?
I can see how you could see two black plassy plugs where the replaceable brushes could be got at to be changed, but wot if there ain't...
FiP's aren't for the faint hearted.
There are a number of specialists that will rebuild it for you, at a cost, Diesel Bob is one i've used.
http://www.dieselbob.co.uk/injectionpumps.aspx
Also heard good things of these people ...
Both my rear door window trims have seen better days. The other day at breakers there were both sides available in better nick than mine so whilst there got my hand in pocket and splashed out.
First step today was to get old ones out. Its easier...
Hi all discovered the problem on the old girl, it turned out to be a seized pulley on the AC compressor. Swapped it out for a new one and all is good she running 100% better and smoother and has the excelleration back.
Massive thanks to everyone...
Phone around and don't accept any BS. Your age, driving experience, vehicle and postcode are unique to you, so do the hard yards and call them all.
FWIW, I'm in the insurance business, although not on the motor side, but I know how the risks are...
Thank you for your welcome and thank you all for being so welcoming and positive!
I hope for fun times too. Will introduce him and me when he arrives next week.
There’s a wonderful spooky twist to this tale too relating to my original one 25...
Easy question. D3 suspension lift options. Obviously +2” air to spring conversion. But I’d like to keep the air suspension while it works. I’ve seen the Fully Adjustable Suspension Lift Rod Kits, are these any good? Are they a good idea for a...
HI Yantojarc
I agree with Nodge68, I think I am having issues with my fuel filter which was not a genuine filter , when hot does not seem to respond to throttle all the time.
Just went to start my lannie, it started after about ten seconds of turning over (which has become common since about 12 months ago). Checked underneath it... spot of liquid and drip drip drip.
I was hoping it was maybe the lift-pump (I've got a...
When I eventually get my compressor replaced on the green P38, I will be using a regular garage refill. Cheaper than 4 cans for the P38 1200g requirement !!
Thanks Arctic2 for your response, reason I am asking is I have read that on some filters that the valve in the filter that controls the fuel temperature does not work correctly?:rolleyes:
Thanks again TK MAX.