Kadonkadonk1
Member
- Posts
- 73
- Location
- Cardiff
would it be safe to drive a d2 with 2 loose propshaft bolts. One on the front and one on the rear. The others are still in place.
Would it be safe ?
- Thread starter Kadonkadonk1
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Bantam1
Well-Known Member
- Posts
- 1,630
- Location
- North Wales, UK
Depends what you mean by loose.
If they jam in the uj you could have a uj failure and a prop come off.
The outcome of that could well be very dangerous and hence unsafe.
If they jam in the uj you could have a uj failure and a prop come off.
The outcome of that could well be very dangerous and hence unsafe.
Kadonkadonk1
Member
- Posts
- 73
- Location
- Cardiff
They are loose as they've probably been turned about three turns and then the nut rounded
Bantam1
Well-Known Member
- Posts
- 1,630
- Location
- North Wales, UK
Oh I see!
Do you need to wait until you have time to get at them and cut them off to replace?
If the others are tight I suppose one slightly loose isnt that big an issue but I wouldnt assume you can drive like normal and ignore it for any time.
Do you need to wait until you have time to get at them and cut them off to replace?
If the others are tight I suppose one slightly loose isnt that big an issue but I wouldnt assume you can drive like normal and ignore it for any time.
discool
Well-Known Member
- Posts
- 13,627
To get u home or to a place where replacement can be carried out, plus you’re using diving carefully “limp mode” if you have too.
