Woodburning Stove

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
What size opening does it have to fit & what output are you hoping for.


I've got this..

RPhoto0098.jpg



:D :D
 
Ah Pikey it's for the living room so ideally looking for something a little more appealing to the eye ;)

Output: 6.5kw upwards I think....more concerned with the cost :)


Here you go 7kw-8kw | Wood Burning Stoves they are just a simple cast iron box with a grate, very rugged and simple to light/operate. I've had a Woodmaster 2 for a few years now.

I've seen better stoves (more controllable etc etc) but not for less than £1000.
 
so, a couple of things. you know that you are meant to have the installs certified? If not, be safe when fitting and know you have ruined your insurance.

cheap chinese stoves are exactly that. you can get good make scruffy second hand and clean them up and replace the parts for around 200 if you keep an eye out (check gumtree local as they have heavy cast iron buggers).

don't get an oversized one for the room. really, you are meant to put in a dedicated air vent over 5kw iirc.

an oversized one means you will either be sweating your balls off and using loads of fuel, or not running it hot enough so it will be inefficient.. and use lots more fuel.

the install will make as much, if not more difference as the actual stove will.

also go for multifuel.
 
Then they got to be careful when adding a wood burner then. Have seen to many fires, people killed usually while they sleep because of a DIY installed wood burner............ Well i hooked it to the chimney


Different house building methods in uk. Timber built houses are almost unknown in UK most of ours are brick built, the timber framed ones usually have brick/block/concrete gable ends with timber fronts and rears. Carbon Monoxide poisoning is bigger killer especially with modern double glazed housing.
 
You need to measure the size of the room so you know what size woodburner you need, you can put the numbers into this online calculator also see the considerations on that page for a better clue.

If you're in a smokeless zone (or other planning restrictions) this will limit the type of stove you can fit.

You can get also some good advice from a good stove/woodburner shop, who should give some clues as to regs, what you need flue wise, and costs.

Do you have a chimney already? If so it'll probably need a liner, size depending on the stove, may also need a register plate. Otherwise you can use stainless steel twinwall, expect to pay over a grand for twinwall flue. Either is easy enough to fit yourself once you're familiar with the regs which are all available online, twinwall is as easy as leggo, just clips together, how high you need it depends on the situation, the regs explain it pretty well, maybe look at installation instructions for a particular stove, and/or particular flue manufacturer like Selkirk or Poujoulat.

DIY is OK but you'll need it tested & signed off by a HETAS engineer if you don't want to invalidate insurance.

to give you a clue on costs, I've fitted two different stoves in our place, cheapest stove was £400, the twinwall flue for that was £1200 with 45% selfbuilders discount straight from the wholesalers :eek: expect to pay more if someone else is installing it ;)

Pumpy
 
If you're in a smokeless zone (or other planning restrictions) this will limit the type of stove you can fit.

You sure that's right? Afaik, you can install any old stove but must use smokeless fuel.. or you can use an authorised stove and use wood.
 
Back
Top