wont start

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
wrxfifer

wrxfifer

Active Member
Posts
916
well as above thats it all back together and wouldint even start till i stuck this eka code thing in with the key still getting all the eas faults coming up but it turns over but wont start i have double checked and triple checked all coil packs and leads have taken plugs out and pressure tested again seem fine plugs covered in petrol so out drying the now but thing wont go ??
stuck £35 petrol in it 5 minutes before all thid happened with head gasket and its only just registering in the red now and theres been no loss where its sat ever since where should £35 register? is it maybe that the suspension has went right down to the wheel arch and is leaning back gauge is reading this? have checked for leaks around tank cant see or smell anything really?
IM STUCK AGAIN LOL
will this eas stuff go off when i get it going?
 
ok befor you try to start reset all windows and anything else it tells you in one movement window down to bottom then back up do this to all of them if you have sunroof do the same open close tilt close then try starting i know it not easy all the **** you had over last few days but stay calim
 
right i see what you mean to set everything it accepts it but the bonnet open light has been on since i got it and wont go off so does this mean it wont start till i solve this problem?
 
ok now bonnet is a micra switch i think its ondrivers side cant remeber may be my age have a look and se if you can get it to go off but it should not stop it starting have you tried it again since you did reset?
 
i have just replaced all the plugs again as one looked bad! too and still same wont start!
aarrgghh
 
its like the bonnet clicks in as far as im concerend but sits high? and wont force down the other half inch its ment to and thing wont start after reset?
 
i know we all been here have you got old plug? pull a lead and make sure you got spark have to run through one thing at a time
 
should the numbers on the coil pack frame correspond to the correct plugs on cylinders?
 
i put them back on as they were when i got it and drove it home? maybe they were already wrong? but i drove it home?
 
yes there spark? and the corresponding numbers on coil packs to cylinders the leads dont even reach where there ment to anyway?
 
its getting spark! and theres petrol there also? must befiring at wrong time??
was never near the timing though??
feel like setting fire to it i have nearly had it lol
 
so you have spark you got petrol on your plugs it got to be some thing stupid i know you been all over it but you just got to do it again crank senser cam senser al wires you have taken off or could have moved
 
You must log in or register to reply here.

Similar threads

Montyjohn
P38A Adding a valve to manually fill EAS tank and why did my pump fail again?
Replies
14
Views
1K
Datatek
Datatek
feyniriel
P38 EAS problems
Replies
18
Views
1K
pwood999
pwood999
M
Range rover evouque 2021 ambient lighting issue
Replies
8
Views
565
backinblack
backinblack
tarphenry
P38A Starting mystery ( Diesel)
2
Replies
33
Views
2K
tarphenry
tarphenry
J
P38A p38 EAS - immediate drop of pressure
Replies
11
Views
718
Mark Piercy
Mark Piercy
Back
Top