sandyt
Well-Known Member
- Posts
- 1,615
- Location
- Wraysbury Nr Heathrow
Which tyres and marks out of ten?
Which tyres are you running?
- Thread starter sandyt
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
sas1810
New Member
- Posts
- 1,347
- Location
- back in Willenhall, West Midlands.
265/65/16 on a 2001 4.6 Vogue. general grabber AT2. only had them on today, but MUCH better than the 20's i had on.
Soloby Rob
Banned
- Posts
- 7,714
- Location
- In a house, not far from somewhere
:doh:ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ
16" Scorpions on the front and Grabbers on the back.
Did the recent chippie run and had no issues staying with the Discos and Defenders.
Drive up to Perth two or three times a year, no issues / noise at high speed.
Will be replacing the Scorpions with Grabbers when the time comes.
Did the recent chippie run and had no issues staying with the Discos and Defenders.
Drive up to Perth two or three times a year, no issues / noise at high speed.
Will be replacing the Scorpions with Grabbers when the time comes.
kevwill
Active Member
- Posts
- 930
- Location
- Sunny Hastings
round black ones10/10 i'd fit 'em again
You should change them...10/10 doesn't sound the right size to me
You should change them...10/10 doesn't sound the right size to me
yikes
what tyres do you recommend for my truck????????
kevwill
Active Member
- Posts
- 930
- Location
- Sunny Hastings
yikes
what tyres do you recommend for my truck????????
How am I supposed to read what you write with all that bouncing going on??:bowl:
- Posts
- 58,170
- Location
- Preston Lancs.
400 x 20 x 28. Had a hell of a job cutting the bodywork back with the stihl saw to make em fit. Look good now though, when i file the jagged edges down on the wings it will look even better.
kevwill
Active Member
- Posts
- 930
- Location
- Sunny Hastings
I find these are best for winter.....
:rolly:
:rolly:langley
New Member
- Posts
- 372
- Location
- Bristol UK
400 x 20 x 28. Had a hell of a job cutting the bodywork back with the stihl saw to make em fit. Look good now though, when i file the jagged edges down on the wings it will look even better.
If you leave the jagged edges on there it will help rectify the tyre wear issues from the excess camber...
sandyt
Well-Known Member
- Posts
- 1,615
- Location
- Wraysbury Nr Heathrow
rasheed
Well-Known Member
- Posts
- 1,815
- Location
- Bangladesh
- Posts
- 58,170
- Location
- Preston Lancs.
sas1810
New Member
- Posts
- 1,347
- Location
- back in Willenhall, West Midlands.
Thanks you're a star, never thought of that will leave them rough.
are you running a bit like this then Wammers?
Attachments
mozz smith
Well-Known Member
- Posts
- 1,700
- Location
- tameside manchester
400 x 20 x 28. Had a hell of a job cutting the bodywork back with the stihl saw to make em fit. Look good now though, when i file the jagged edges down on the wings it will look even better.
toe your funny mate ,i thought any minute now someone will put ROUND RUBBER ONES , but yours was the best cheers mozz
Datatek
Well-Known Member
- Posts
- 46,040
- Location
- Near Poitiers SW France
sas1810
New Member
- Posts
- 1,347
- Location
- back in Willenhall, West Midlands.
Another air suspension failure by the look of it
purpose built! you can actually buy, for a price, a set of off camber stub axles that give you that look. tyres last about 500 miles if you are lucky
