What have you done to your Landie today.

discomark10 said:

where u get em from?

Click to expand...

If you put lorry heated seat pad into that special blagging place they are there

Replaced bearings on swivel ball and found knackered wheel bearing on back wheel

Finished the front end including her new lights.

Looks good. Is it staying now?

I really don't know. I want her to. But, a move to Aus is on the cards and i can't see them letting me import her due to the colossal amount of environmental damage she would introduce.

Dr No said:

I really don't know. I want her to. But, a move to Aus is on the cards and i can't see them letting me import her due to the colossal amount of environmental damage she would introduce.

Click to expand...

There are plenty over there already. Get one there maybe?

chunkymunky said:

There are plenty over there already. Get one there maybe?

Click to expand...

That's the general idea cash permitting, depends on how my job hunting works out.

Eventually got around to replacing the motor for the front window, replaced the springs in the rear door two days ago, so as it is there is nothing not working correctly on the car at the moment...............

Fitted me new seats from vilguy , they're out of a smart car and look great.

finally wired two foglights up, through dip beam as a feed to switch then to the relay on.
bit of luck I can see at night!
I also fitted a splash guard, cut down from a diesel mondeo one I had, held onto the chassis by big (B I G) cable ties.
I got fed up losing my alternator & power steering in splashy wet "puddles"
and "stuff"
If it gets buggered, it cost me nought to start with..

turned my pump down 1/2 turn now i can see were ive been still got the power lol

Thought I had better get my ass of the sofa and replaced rocker box gasket,checked and adjusted tappets and cleaned breather,drained clutch fluid and replaced with new( took 5 pots of fluid to flush through the system until I got clean fluid) and checked all wiring relating to fuel and temperature gauge and I still can't get them working ? But I did get a few jobs sorted.

Stuck on a rather dashing "DEFENDER 90" decal on the back just below the landrover badge (where it should be)

Daz

bigsi13 said:

Fitted me new seats from vilguy , they're out of a smart car and look great.

Click to expand...

Easy fit? I see the back is thinner so goes further back?

Changed a bolt.

The Mad Hat Man said:

Changed a bolt.

Click to expand...

Awwwww you must be knackered. Put yer feet up

Filled it with fuel. Drove it to nooberry and spent loads of money on it..

chunkymunky said:

Easy fit? I see the back is thinner so goes further back?

Click to expand...

They sit about the same, just a little tighter due to truck cab back, in a van they'd be perfect mate. Really easy fit just drilled 2 new holes and there in

Put my new boot floor in .

chunkymunky said:

Awwwww you must be knackered. Put yer feet up

Click to expand...

I am

mind yu - helping Snifflebag fit front diff guard, steering guard and fuel tank guard to his motor mite have summat to do with that .