What have you done to your Landie today.

Did some lanes and fords on me jack jones

is that wise?

Freelaner said:

is that wise?

Click to expand...

Do it every time i go to the office

stripped out my rollbar ready to de-rust it and repaint it. Its 90% good apart from the bottom of the mounts which are rusted.

Also removed door tops to check the integrity of the doors, they are all ok. might leave the door tops off though in the hopes of warm weather!

Parked it on my friends drive to protect her mini whilst shes away

Picked up a tatty pair o cheap buckets for me 90

looked at the rust on the d1 and thought fook it had a cup of tea instead

Given up, going to finish the jobs I have already got the bits to do.

Then going to find a local garage that does Landys

suew said:

Given up, going to finish the jobs I have already got the bits to do.

Then going to find a local garage that does Landys

Click to expand...

What ya given up on?

Did what I thought was prelimary fault-find on engine failing to warm up, fully expecting to be ordering a new stat at the end of it (TD5 disco - needle stays at 1/3, rarely getting to 1/2 like it's suppsed to)

Checked ECT sensor resitance with multimeter, all within spec. Checked for continuity and shorts between ECU and sensor, all good. Oh well, must be thetmostat then, but then on the next run she warms up to 1/2 within 5 miles, just like old times.

Conclusion: must've been a little bit of resistance in one or the other of the loom connections that got fixed by unplug and reconnect. Either that or failing wiring - we shall see

Set the tappet clearance ( i think ). Now waiting for battery to charge so i can attempt to start the thing for the millionth time.

craigyb said:

What ya given up on?

Click to expand...

DIY

ran out of derv in the td5 thought it was going to be a right pain to get going but primed it and started first couple of cranks happy days

Cleaned my interior.......it was diiiissguussting

Checked all levels under the bonnet and topped up as needed, since I've been working shifts in work I've barely used the land rover because I've been sharing a lift, makes a difference

Finally sorted out what was squeaking after changing the timing belt, tensioner and a variety of seals and gaskets, yippee!

Thanks to the amazing researched capabilities of Mr Freelaner!

fookall Watched beasty poke and swear at his though





Sorted my tools and as I've pikied all my **** back form Robint I've cleared out a corner of The woirkshop. and set up the compressor, moved me tool box over and dragged the welder out from under all the other ****e that's piled in there..

Swore at it.....pulled various bits off.....swore at them......stuck them back on again......swore and went home

blue beasty said:

Swore at it.....pulled various bits off.....swore at them......stuck them back on again......swore and went home

Click to expand...

It needs a new owner :-D. Still issues with heat and starting?

looked to see why my newly acquired old fender is making noises on left hand lock, bloody wheels hitting the drop link ,while a was down there noticed a bit of crustyness to the floor pan its totally fookedso pre occupied with checking the chassis forgot about the floor,then i said fook it and took it for a quick spin off road