What have you done to your Landie today.

3.5 efi said:

will have been valve leaking due to not seating properly nick

Click to expand...

hope so.....


otherwise i will be puttin the spare on again in the mornin...

i always check mine by spitting on them after

Fitted a new rear wheel bearing. Was quite alarmed to find so much clay mud where the bearing should have been!
Hate doin wheel bearings, but has to be done...especially when the noise from the knackered one actually drowns out the noise from the cherry bomb exhaust!!!

3.5 efi said:

i always check mine by spitting on them after

Click to expand...

thank fook you aint a chef Vince!!!...

According to the LR manuel for 750X16 in psi is 28 front and 48 rear for normal driving conditions. For Emergency soft 16 front 16 rear unladen loaded 16 front and 23 rear
This is for a 110.

48psi?

that seems high....

might help with the rediculous roll though...

cheers..

joe1972 said:

Fitted a new rear wheel bearing. Was quite alarmed to find so much clay mud where the bearing should have been!
Hate doin wheel bearings, but has to be done...especially when the noise from the knackered one actually drowns out the noise from the cherry bomb exhaust!!!

Click to expand...

after doin a full injun rebuild ya complain bout swoppin a poxy wheel bearing... its a 15min job....

doin it takes less time than complainin bout it!! man up!!!!!

That's what it says in the Land Rover Hand book for a 110.

nick2303 said:

after doin a full injun rebuild ya complain bout swoppin a poxy wheel bearing... its a 15min job....

doin it takes less time than complainin bout it!! man up!!!!!

Click to expand...

Yeah I know...its not difficult...it's just one of those jobs I love to hate...and complain about

3.5 efi said:

will have been valve leaking due to not seating properly nick

Click to expand...

Err OP said he had a tube in it it might be a leaky valve but "seatin' an't got now't to do we' it" (that's Yorkshire speak)

valve seating

Went out to fit a new radiator, rain started so came back in again. Try again tomorrow

Had a general maintenance sesh this afternoon, tightened up the steering box, what a difference! Also tightened a front wheel bearing (no more clunking), and tightened the fan and alternator belts (no more squealing). Lots of tightening.

Tomorrow's plan is to take off my 265s to sell them, and put back on the old 7.50s, in preparation for getting my 35s

Hi Guys i have damaged my disco 2 front bumper beyond repair and i was thinkin of fitting a winch bumper.
any ideas on which is the best and where to purchase one?
Any help is appreciated.
Cheers

Set off the SRS by mistake so gotta get that fixed tomorrow and fit the bullbar seeing as I've finished covering up the rust on it…….plus it was soaking today

Took my daughter to her dancing / singing lesson and ended up having to get her to donate her pretty purple tights to make a fanbelt to get us home!

Bull bar fitted and now just needs a bit of paint on the washers and where I've managed to scratch a bit off!!

Need to reposition the numberplate now!!

All this gale force winds and driving rain has cleaned my Defender up a treat.

took its chassis in to be hot galv dipped

Fitted my ibm thinkpad (on laptop mount)for gps
Installed 4 gang cig plug extension