What have you done to your Freelander today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Replaced OSF brake sensor, 3 amigos and handbrake warning light now extinguish on delay after the ignition is switched on, But, the handbrake warning light does not come on now with the handbrake applied
 
Drove home from the garage with no diff as couldn't find a prop bearing in time the back end started to steer all by itself not far from home just pulled into the car park at home and bits came a falling off I'm guessing the hub or bearings destroyed itself..
Will need to take it to bits tomorrow and be having a looksee
 
Drove home from the garage with no diff as couldn't find a prop bearing in time the back end started to steer all by itself not far from home just pulled into the car park at home and bits came a falling off I'm guessing the hub or bearings destroyed itself..
Will need to take it to bits tomorrow and be having a looksee


Did you leave the driveshafts out? If you did the cv joint holds the wheel bearing together!
 
Yep no drive shafts in at the min, this is part of what ever fallen off..
 

Attachments

  • 20140927_180748.jpg
    20140927_180748.jpg
    149.4 KB · Views: 165
New rear shocks (ball ache as good old LR decided that when changing the rear shocks it would be a good time to split the brake pipes where they meet the flexi! Then of course the bleed nipple was a pain!). Also fitted a new wiper motor and checked air in tyres :)
 
Last edited:
I cleaned it ,, got plastic trim back to original colour cleaned underneath as well 3 hours then my other half cleaned inside ,then decided she wants to drive it to work and not her car :(:car::car: I just put petrol in it too
 
I did my first ever brake pad change today and it couldn't have gone any better :clap2:

I also resprayed my spare wheel/brake light housing, really pleased with result. Have attached a pic:
 

Attachments

  • image.jpg
    image.jpg
    283.2 KB · Views: 216
i repaired my rover ron synergy tuning box after i had a slight whoops and shortcircuited it...

working again now :)
 
Back
Top