Andy Philpott
New Member
- Posts
- 4
- Location
- Dover
What goes in this hole!?!?
- Thread starter Andy Philpott
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hicap phill
Well-Known Member
- Posts
- 16,320
- Location
- Wiltshire
It’s a wading plug hole
Andy Philpott
New Member
- Posts
- 4
- Location
- Dover
Should it be in there? Or should I be worried that it's not in there?
This is my first defender, so forgive my lack of knowledge
This is my first defender, so forgive my lack of knowledge
Hicap phill
Well-Known Member
- Posts
- 16,320
- Location
- Wiltshire
Unless you go through deep water you don’t need to worry.
The bung just stops water getting onto the clutch when wading.
Andy Philpott
New Member
- Posts
- 4
- Location
- Dover
Thanks for your response, that's put my mind at rest!
GRATCH
HUGE MEMBER
- Posts
- 15,501
- Location
- North Cheshire
You should remove the bung after wading so the oil from various leaks can drip out and not fill the bell-housing with oil. Which would be bad for the clutch.
Andy Philpott
New Member
- Posts
- 4
- Location
- Dover
I'm glad you said that, I was just about to order one to put in. I shall still but just have it ready to go. Thanks
- Posts
- 4,603
There are two drainage/wading holes .. one bottom of the front timing cover and the other bottom of the clutch bell housing (the one you found).
Leave the holes 'open' unless you plan to go through water that is 500mm or more deeper or if you are driving through a lot of sloppy mud and puddles (say at a pay and play day) and then take them out when you get home/after you have washed under the engine etc.
Leave the holes 'open' unless you plan to go through water that is 500mm or more deeper or if you are driving through a lot of sloppy mud and puddles (say at a pay and play day) and then take them out when you get home/after you have washed under the engine etc.
Similar threads
