RS2000CUSTOM
Active Member
- Posts
- 346
- Location
- The Black Country - The Miglunds
Otherwise he will break it ! 
I had been to VMTP this morning for oil change and Ecu check - all good no errors
On the way home I called in at his Tyre Emporium and offer him the keys to my TD6 so he can see how my new TC and Cleaned out gearbox performs
Well he gets in turns key and before it starts the dash starts flashing and bleeping - Trans Fail Safe Prog :censored:
Key off and back on Message now clear
So off I go back to VMTP (just incase a fault had occured) - only stored error was can bus comms error
Carried out hard reset and drove - ALL NOW GOOD
I have just completed 30 mile going in and out of Sport / Manual and Normal Mode - Hi-Lo range - EAS Off road, Motorway etc etc etc
Turned key on/off/on - no faults
So morale to story is DONT GIVE wil2813 YOUR KEYS ! - lol :bump2:
I had been to VMTP this morning for oil change and Ecu check - all good no errors
On the way home I called in at his Tyre Emporium and offer him the keys to my TD6 so he can see how my new TC and Cleaned out gearbox performs
Well he gets in turns key and before it starts the dash starts flashing and bleeping - Trans Fail Safe Prog :censored:
Key off and back on Message now clear
So off I go back to VMTP (just incase a fault had occured) - only stored error was can bus comms error
Carried out hard reset and drove - ALL NOW GOOD
I have just completed 30 mile going in and out of Sport / Manual and Normal Mode - Hi-Lo range - EAS Off road, Motorway etc etc etc
Turned key on/off/on - no faults
So morale to story is DONT GIVE wil2813 YOUR KEYS ! - lol :bump2:
Last edited:
