valance removed......

Stevekennah · Apr 27, 2014

This morning I've removed the valance.... found all the fittings were fubar , so I've had to drill and bolt the bumper caps back on ...... an industrial look imho

is there anything special that I need to do fit a steering guard?? Special bolts etc

Also I'm after a willow green light finisher hockey stick, where could I get one from? Or are they easy to paint??

Critical Mick · Apr 27, 2014

If I remember correctly you'll need 6 M10x120mm bolts for the steering guard.

biggeeeee · Apr 27, 2014

Stevekennah said:
This morning I've removed the valance.... found all the fittings were fubar , so I've had to drill and bolt the bumper caps back on ...... an industrial look imho

is there anything special that I need to do fit a steering guard?? Special bolts etc

Also I'm after a willow green light finisher hockey stick, where could I get one from? Or are they easy to paint??

:nopics:

haigy · Apr 27, 2014

4 bumper bolt and a bolt to go thru the chassis.the other side goes over the Steering box bolt

haigy · Apr 27, 2014

And spray everything with wd40 before hand and copper grease them when putting back on

Stevekennah · Apr 27, 2014

Thanks everyone.....

Pictures won't upload as I'm doing this off my phone:nopics:

valance removed......

Stevekennah

Active Member

Critical Mick

Member

biggeeeee

Retired - Living the dream

haigy

Well-Known Member

haigy

Well-Known Member

Stevekennah

Active Member

Similar threads