ummm

Matt Baxter · Oct 19, 2011

Just fitted a +2" procomp shocks and bearmach springs but its sitting a bot higher at the front(+1" ish) is this normal or have I ****ed something up?

Is it possible to fit the rear springs on the front and vice versa?

I did fit the spring as per what was written on the boxes ie front on the front and rear to the rear

Any ideas peeps?

jamesmartin · Oct 19, 2011

where springs all the same size or fronts shorter ,v8 or tdi

Matt Baxter · Oct 19, 2011

Tbh I didnt check hights
Its a tdi
Just looking and it says that bearmach front springs are 16mm and the rear are 18mm and have checked mine and they are in the right place so just need to find out if I have been supplied the wrong hight springs as I would have thought the the rear would be a little higher than the front?

jamesmartin · Oct 19, 2011

rears would be higher because of angle of front spring plates ,just ive had some odd hieght kits from bearmach and had to get them changed,v8 as there so light they need a lighter spring

Matt Baxter · Oct 20, 2011

jamesmartin said:
rears would be higher because of angle of front spring plates

not sure I get ya mate

I'm as sure as I can be the springs are in the right place
but am going to pop in to the place where I got them from just to confirm that I havent ****ed it up will prob end up adding a spacer to the rear at this rate just to it sits right

nick2303 · Oct 20, 2011

mine looked like that when i fitted my lift..

swopped springs front to rear and vis-a-versa and sits slightly higher at back now and looks lots better...

Matt Baxter · Oct 21, 2011

little update its all sorted

, had the right box but the wrong springs(only +20mm) all sorted now tho looks soo much better now so went for a little play through a ford

ummm

Matt Baxter

Active Member

jamesmartin

Well-Known Member

Matt Baxter

Active Member

jamesmartin

Well-Known Member

Matt Baxter

Active Member

nick2303

Well-Known Member

Matt Baxter

Active Member

Similar threads