Turbo sealkit

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Turbo Repairs Blackpool - 01253 407 646 - best part of £100 for the last kit i had off them
 
that was 18 months or so - tend to just buy a good used turbo instead these days

the bearing and seal kit is over £250 !
 
Sean said:
that was 18 months or so - tend to just buy a good used turbo instead these days

the bearing and seal kit is over £250 !
Click to expand...

thats a bloody expensive bit of rubber, I know they have to take the heat but jesus.

May reconsider rebuilding it at that, certainly not but the value back in the motor....
 
andyb66 said:
Are you looking for a 19J turbo? I have one still on the exhaust manifold.
Click to expand...

Possably, going to rebuild the one i have before fitting it in my series but if its not to bad i'll leave it.

Then engine has done 96k, and from what I can gather problems start around 120k
 
G-man said:
you should have yer shaft balanced if you are stripping the turbo as they tend to beat themselves if they are out of balance ( it makes one hell of a mess too)
Click to expand...

your making it sound worse:D, I have got two here is non of these are any good I may be in touch with andy;)

sound like the rebuild is out of the window
 
G-man said:
i have a 19j engine with a turbo on it you can have.... providing you take the whole engine (its the one i got off of pete23 on olhi) the engine is good for bits but the injection pump is suspect
Click to expand...

arghhh not another one i have 2 already :eek: but i will keep it in mind;)
 
a bit i used me hot air gun as it goes up to 600 degrees so i could get the worst out, but the rest of the landy is battered so it would look odd being smooth, i really need to give mine a new chassis, so what i might do is use my body and make a hybrid on a disco chassis and get it registered as a disco hybrid
 
G-man said:
a bit i used me hot air gun as it goes up to 600 degrees so i could get the worst out, but the rest of the landy is battered so it would look odd being smooth, i really need to give mine a new chassis, so what i might do is use my body and make a hybrid on a disco chassis and get it registered as a disco hybrid
Click to expand...

sounds like a good plan, disco's dont cost the earth do they
 
You must log in or register to reply here.

Similar threads

Seph98
Turbo Hoses with oil
Replies
7
Views
863
miktdish
miktdish
V
TDCI 2007 What is this for?
Replies
0
Views
264
vtwin
V
R
Td5 late boost
Replies
18
Views
750
Rimas
R
B
Turbo problems
Replies
0
Views
279
Brian Camplin
B
Smoking90
Advice for repair.
Replies
2
Views
1K
QuintinC
Q
Back
Top