Transfer box pto plate?
- Thread starter leeby7
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
they are a good fit so often tight ,apart from been glued by gasket or sealer
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
Sometimes the beating retaining ring (between the pto plate and the transfer box casing) has a seperate screw securing it. It may just be stuck on with gasket.
Clean the face you can see to check for a screw, if there isn't one a few gentle taps with a rubber mallet might loosen it a touch.
Mine was stuck on with rtv sealant and needed prising off.
Once that's done the bearing and gears should eventually wiggle out
Ed
Clean the face you can see to check for a screw, if there isn't one a few gentle taps with a rubber mallet might loosen it a touch.
Mine was stuck on with rtv sealant and needed prising off.
Once that's done the bearing and gears should eventually wiggle out
Ed
