Hmm, found this over on RR
http://www.rangerovers.net/forum/7-...90-p1708-resolution-hopefully.html#post304278
http://www.rangerovers.net/forum/7-...90-p1708-resolution-hopefully.html#post304278
P38A Transfer Box changed - some problems
- Thread starter domino
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 58,170
- Location
- Preston Lancs.
Neutral switch on auto is in XYZ switch. But there is a Low selected switch in the gear selector base i believe. Maybe they have pulled the wire for it. It goes in through a grommet at back of gear selector box.
- Posts
- 58,170
- Location
- Preston Lancs.
Look in RAVE 1999 on electrical trouble shooting for connector C0673. If that has been pulled off or partially displaced it may give your problem.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Well you could move in high, with all the bells and whistles.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Don't forget your passport if your going to Newcastle.
- Posts
- 58,170
- Location
- Preston Lancs.
Don't forget your passport if your going to Newcastle.
Met an educated Geordie once. He could say wye aye in three languages.
- Posts
- 58,170
- Location
- Preston Lancs.
It would be pretty obvious if it was in low range. Did you check the switch i mentioned?
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
- Posts
- 58,170
- Location
- Preston Lancs.
Hope your boiling your water Tony.
Yep. But with all the bloody chemicals they already put in i am surprised anything could possibly live in it.
Not yet - need to find 10 minutes to strip the console out to check out. Trying to do it all around moving and phonecalls etc is a pain in the arse.
Need to find a 10amp fuse too... and it's all packed away!
- Posts
- 58,170
- Location
- Preston Lancs.
Should be a spare in the engine bay fuse box. Still think it's likely if the new transfer motor is sound that they pulled the harness and dislodged the CO673 plug.
- Posts
- 58,170
- Location
- Preston Lancs.
Indicators are a function of the BECM. Can't see how what you have would effect indicators, but maybe a bad connection has glitched BECM.
In the RR post, the guy had the same problem. Replaced the motor and that seemed to cure his issue (same symptoms and fault code).
Just stripped it all and can see no issues with the switch but will try the fuse method once I've put it back together.
Just stripped it all and can see no issues with the switch but will try the fuse method once I've put it back together.
