THAT circlip on the primary shaft

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
S

sprie

Active Member
Posts
232
Trying to fit THAT circlip on the gearbox primary shaft.

I have watched SteamWally's YouTube video, and he says he uses a ring of steel lengths that fit in the grooves, held together with tape - so he can slip the circlip over and gradually move circlip over the shaft.
I don't have a set of steel pieces that would fit.
I therefore wasted 45 minutes using circlip pliers (which slip off) and screw drivers (only have 2 hands, so they slip off), and have made no progress.

Any suggestions?
 

Attachments

  • 20240205_120858.jpg
    20240205_120858.jpg
    218.6 KB · Views: 87
Not much of a useful reply but I did it using 2 or 3 small screwdrivers and a bit of swearing, once its started on the shaft a bit of tube to knock it down into place
 
From memory you have to take that circlip off and on a few times to set the clearances, unless you are very lucky and get it first time.
I don't remember putting it on to be the problem, it was getting it off that was difficult.
 
If it was me, and I’ve never done it, I’d cut three narrow wedges. Pop the ring on top of the splines and open it up by tapping the wedges into the splines. Once on the splines it should tap down.
 
It's a swine, and crucial to the end float, I think.

I've used a half one to set end flat and then put the proper one at the end. Ensuring both the same width, of course.
 
You must log in or register to reply here.

Similar threads

S
Prop shaft
Replies
3
Views
412
Chris_68
C
UpandOver
Adwest 4 bolt steering box input shaft seal - help!
Replies
1
Views
1K
tottot
tottot
S
fitting transmission brake
Replies
4
Views
654
tottot
tottot
F
Landrover 90 Diff problem?
Replies
10
Views
1K
Anaconda
A
G
Half shaft seals failing repeatedly Discovery 2
2
Replies
20
Views
2K
Gingerbread
G
Back
Top