TD5 door hinges again
- Thread starter sub24
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
greyhair
Well-Known Member
- Posts
- 1,303
- Location
- IN MY SHED
There is a lot around on ebay
have a look at the sp landrover ones, think i will be going with them
have a look at the sp landrover ones, think i will be going with them
kes86
Active Member
- Posts
- 775
- Location
- Isle of Man
There are some heavy duty ones on eBay I was tempted with. I got just the one cheap standard one from the Land Rover parts place in Liverpool on the way to the boat home in August, not fantastic quality but has done the job and less slack than the worn one I took off.
Rusty Spanner
Active Member
- Posts
- 231
aaronmorris
Head's a shed
- Posts
- 6,369
- Location
- Doncaster
Nice I like that idea, and it'd save money too
Does the old pin just knock out or need drilling out?
Rusty Spanner
Active Member
- Posts
- 231
Just Knocks out takes a good wack though, I drilled the top and centre parts of the hinge to 8mm and I tapped the lower parts for an m8 thread, I used an m8 x 80 mm stainless socket cap as the shoulder is about the right length, think I had to cut the thread another couple of mm to allow for the counter sunk head. The door is the best it's been no movement at tall, much better than the cheapo replacements. Think I got the info from a previous post on hear so I'm not the first to do this.
Landyfox
Well-Known Member
- Posts
- 4,489
That's a useful and helpful tip, I like that idea a lot!
aaronmorris
Head's a shed
- Posts
- 6,369
- Location
- Doncaster
Cheers, think I'll give that a bash.
IamRobbie
Well-Known Member
- Posts
- 2,800
- Location
- Derbyshire, j28 M1
tis very impressive!!
I changed my hinges the other week... tried to sort the door lines out, seems my bulkhead wants leaning forwards but just the thought of it kills me..
I changed my hinges the other week... tried to sort the door lines out, seems my bulkhead wants leaning forwards but just the thought of it kills me..
aaronmorris
Head's a shed
- Posts
- 6,369
- Location
- Doncaster
Yep, 'tis a crap job to do, doubt it'll go vary far with the wings still bolted up either, so even worse of a job than if it was in bits.
Tobydog12
Member
- Posts
- 39
- Location
- Surrey, Sussex borders
SPlandrovers supplied mine - seem fine. I was paranoid about getting the old ones off my 2001 TD5 with all the stories. Sprayed WD40 up the bulkhead a few weeks before trying, put penetrating oil on them from outside a few times - they came off first go! wow
IamRobbie
Well-Known Member
- Posts
- 2,800
- Location
- Derbyshire, j28 M1
aaronmorris
Head's a shed
- Posts
- 6,369
- Location
- Doncaster
Might have to go see a mate called Aaron up Doncaster next summer
Ah, yes, not sure I know him to be honest :behindsofa:
Similar threads
