Hello, seems like I managed to break it.
Basically went to replace injector 4, but on while I'm there basis pulled out the rest to change the washers and tidy up.
However after this car does not start. Sounds like losing compression... not sure.
Two mistakes were made. One is I did not let the pipes a bit out so there was air on all of them.
The second one is that I initially fitted the guides of the injectors the other way around. I did try to start it but as expected did not start because the injectors were not seated properly.
Now they are seated properly, electric cleaned the connectors, all seem in order but won't start.
I also changed the glow plugs to bosch ones, then put back the old ones but nothing.
Delphi diagnostics throw no error.
Please, any advise is greatly appreciated.
Basically went to replace injector 4, but on while I'm there basis pulled out the rest to change the washers and tidy up.
However after this car does not start. Sounds like losing compression... not sure.
Two mistakes were made. One is I did not let the pipes a bit out so there was air on all of them.
The second one is that I initially fitted the guides of the injectors the other way around. I did try to start it but as expected did not start because the injectors were not seated properly.
Now they are seated properly, electric cleaned the connectors, all seem in order but won't start.
I also changed the glow plugs to bosch ones, then put back the old ones but nothing.
Delphi diagnostics throw no error.
Please, any advise is greatly appreciated.