hello
having real problems engaging gears, last year i replaced the master cylinder and not long after found it hard to engage 1st gear but plodded along until the slave collapsed the other week so i replaced the slave and fitted a new clutch.
after refitting found it hard to engage 1st & 2nd gears and got harder to engage them all once warmed up, i have bleed the clutch several times now and is a little better but still stiff, so i replaced the master again so now its all been done but still stiff. also every now and again it kicks when rolling stop into 1st gear
any ideas what could be wrong????
i'm thinking could be linkage rods worn as these are a cup and ball set up anyone had this happen???
can these be replaced or refurb'd??
cheers
having real problems engaging gears, last year i replaced the master cylinder and not long after found it hard to engage 1st gear but plodded along until the slave collapsed the other week so i replaced the slave and fitted a new clutch.
after refitting found it hard to engage 1st & 2nd gears and got harder to engage them all once warmed up, i have bleed the clutch several times now and is a little better but still stiff, so i replaced the master again so now its all been done but still stiff. also every now and again it kicks when rolling stop into 1st gear
any ideas what could be wrong????
i'm thinking could be linkage rods worn as these are a cup and ball set up anyone had this happen???
can these be replaced or refurb'd??
cheers
