Switch panel blank

anyone know where i can get one of the swich plates for the right knee switches in a blank??
mines cracked, me fog light switch is dickie, and the rear heater switch died today.
Figure if i get a blank i can put the hazzard switch in, and fit in at least other 3 or 4 toggles for the heater, fog, and whatever i feel like.
Or I can relocate the hazzard to that blank on the under side of the dash, and use the blank for toggles.

failing that ill find a lump of alloy or summat and have a go at making one.

I got a stainless steel one off eBay ,£6 fitted it in five mins. Easiest job I have ever done on a Land Rover.

with cuts outs for the switches. or a blank one? theres loads with the cutouts for the 3 switches, its a blank one im after and drew a blank on the bay.

Best bets probably just a bit of alu I reckon

I picked some up at a show years ago, clip straight in as a direct replacement for an unused switch position.
Mud sell them, just look for Electrical, E-Switches & Mounts, E-Switch Blank. £2.05 each.

I made a switch panel from a scrap boiler case I had.

Litch said:

I picked some up at a show years ago, clip straight in as a direct replacement for an unused switch position.
Mud sell them, just look for Electrical, E-Switches & Mounts, E-Switch Blank. £2.05 each.

Click to expand...

yeah, I know i could get those, but was thinking some toggles would give me some extra switch space for the inevitable spot bar etc without going for the mud/raptor just yet should be able to get an extra 2 at least on there

Bit of scap Ali water jet cutting place next door gave me a scrap piece

Old thread I know but an often asked question and now I have the answer.

Raptor sell them in both SS & black anodised at £5 each.
They don't show them on the website but keep a few handy at the shows as they are always getting asked for them.
When I removed my old switches (everything switched via Carling on the Raptor) I inserted blanks but the plain plate is neater.